An administrator must assign static IP addresses to the servers in a network．For network 192．168．20．24/29, the router is assigned the first usable host address while the sales server is given the last usable host address． Which of the following should be entered into the IP propertied box for the sales server?
Which command displays CPU utilization?
A Cisco router is booting and has just completed the POST process． It is now ready to find and load an IOS image． What function does the router perform next?
In a GLBP network, who is responsible for the arp request?
Refer to the exhibit． What is the meaning of the term dynamic as displayed in the output of the show frame-relay map command shown?
Which IPv6 address is the equivalent of the IPv4 interface loopback address 127．0．0．1?
Users on the 172．17．22．0 network cannot reach the server located on the 172．31．5．0 network．The network administrator connected to console port,issued the show ip route command,and was able to ping the server．Based on the output of the show ip route command topology shown in the graphic,what is the cause of the failure?
Refer to the exhibit． After a RIP route is marked invalid on Router_1, how much time will elapse before that route is removed from the routing table?
The network security policy requires that only one host be permitted to attach dynamically to each switch interface． If that policy is violated, the interface should shut down． Which two commands must the network administrator configure on the 2950 Catalyst switch to meet this policy?
Refer to the exhibit．All switch ports are assigned to the correct VLANs, but none of the hosts connected to SwitchA can communicate with hosts in the same VLAN connected to SwitchB． Based on the output shown, what is the most likely problem?
Which are valid modes for a switch port used as a VLAN trunk?
Which commands are required to properly configure a router to properly configure a router to run OSPF and to add network 192．168．16．0/24 to OSPF area 0?
Which additional configuration step is necessary in order to connect to an access point that has SSID broadcasting disabled?
Host 1 receives a file from remote server 1． Which MAC address appears as the source address in the header of the frames received by Host 1?
Refer to the exhibit． Router1 was just successfully rebooted． Identify the current OSPF router ID for Router1．
On corporate network, hosts on the same VLAN can communicate with each other, but they are unable to communicate with hosts on different VLANs． What is needed to allow communication between the VLANs?
What is the purpose of the inverse ARP?
What are two recommended ways of protecting network device configuration files from outside network security threats?
In a switched environment, what does the IEEE 802．1Q standard describe?
Why has the network shown in the exhibit failed to converge?