Refer to the exhibit．which address and mask combination a summary of the routes learned by EIGRP?
Refer to the exhibit． A network technician is asked to design a small network with redundancy． The exhibit represents this design, with all hosts configured in the same VLAN． What conclusions can be made about this design?
Given an IP address 172．16．28．252 with a subnet mask of 255．255．240．0, what is the correct network addres?
A Cisco router that was providing Frame Relay connectivity at a remote site was replaced with a different vendor's frame relay router． Connectivity is now down between the central and remote site． What is the most likely cause of the problem?
which address range efficiently summarizes the routing table of the addresses for router main?
Refer to the exhibit． A network administrator is adding two new hosts to SwitchA． Which three values could be used for the configuration of these hosts?
Refer to the graphic． A static route to the 10．5．6．0/24 network is to be configured on the HFD router． Which commands will accomplish this?
Refer to the exhibit． The partial frame shown in the exhibit displays select header information as it arrives at the destination host． Which graphic represents the correct header information in the responding frame returned to the remote host?
You have been asked to come up with a subnet mask that will allow all three web servers to be on the same network while providing the max number of subnets．Which network address and subnet mask meet this requirement?
Refer to the exhibit． According to the routing table, where will the router send a packet destined for 10．1．5．65?
Refer to the exhibit． What kind of cable should be used to make each connection that is identified by the numbers shown?
The command frame-relay map ip 10．121．16．8 102 broadcast was entered on the router．Which of the following statement is true concering this command?
At which layer of the OSI model is RSTP used to prevent loops?
Refer to the exhibit． Switch-1 needs to send data to a host with a MAC address of 00b0．d056．efa4． What will Switch-1 do with this data?
What OSPF command, when configured, will include all interfaces into area 0?
In an Ethernet network, under what two scenarios can devices transmit?
Refer to the exhibit． The Branch router displays knowledge of a route to network 172．16．0．0/16． The actual network number at headquarters is 172．16．1．0/24． Why does the network number appear as it does in the routing table?
Refer to the exhibit． Which two statements are true about interVLAN routing in the topology that is shown in the exhibit?
Refer to the exhibit． Two buildings on the San Jose campus of a small company must be connected to use Ethernet with a bandwidth of at least 100 Mbps． The company is concerned about possible problems from voltage potential differences between the two buildings． Which media type should be used for the connection?
Which two practices help secure the configuration utilities on wireless access points from unauthorized access?