Which two are features of IPv6?
What can a network administrator utilize by using PPP Layer 2 encapsulation?
Which command reveals the last method used to powercycle a router?
Refer to the exhibit． What switch proves the spanning-tree designated port role for the network segment that services the printers?
What is the function of the command switchport trunk native vlan 999 on a switch?
Refer to the exhibit． The network administrator has discovered that the VLAN configuration of SwitchC is ot synchronized with the rest of the switched network． Why is SwitchC not receiving VTP updates?
There are no boot system commands in a router configuration in NVRAM． What is the fallback sequence that the router will use to find an IOS during reload?
Which command enables IPv6 forwarding on a cisco router?
Refer to the exhibit．A technician has installed SwithchB and needs to configure it for remote access from the management workstation connected SwitchA Which set of commands is required to accomplish this task?
Refer to the exhibit． All of the routers in the network are configured with the ip subnet-zero command． Which network addresses should be used for Link A and Network A?
Refer to the exhibit． Host in network 192．168．2．0 are unable to reach hosts in network 192．168．3．0． Based on the output from RouterA, what are two possible reasons for the failure?
Host 1 sends a request for a file to remote sever1． Which destination address does Host 1 place f the packet containing the request?
What authentication type is used by SNMPv2?
Refer to the exhibit． Assume that all router interfaces are operational and correctly configured． In addition, assume that OSPF has been correctly configured on router R2． How will the default route configured on R1 affect the operation of R2?
Refer to the topology shown in the exhibit． Which ports will be STP designated ports if all the links are operating at the same bandwidth?
Refer to the exhibit．Switch-1 needs to send data to a host with a MAC address of00b0．d056．efa4．What will Switch-1 do with this data?
Refer to the exhibit． Which of these statements correctly describes the state of the switch once the boot process has been completed?
Which three Layer 2 encapsulation types would be used on a WAN rather than a LAN?
Which encryption type does WPA2 use?
An access list was written with the four statements shown in the graphic． Which single access list statement will combine all four of these statements into a single statement that will have exactly the same effect?