What are the three things that the Netflow uses to consider the traffic to be in a same flow ?
Which command can be used to verify the DLCI destination address in a Frame Relay static configuration?
Which set of commands is recommended to prevent the use of a hub in the access layer?
Which three statements are correct about RIP version 2?
Refer to the exhibit．Which is the most efficient summarization that R1 can use to advertise its networks to R2?
Refer to the exhibit．Assuming that the entire network topology is shown, what is the operational status of the interfaces of R2 as indicated by the command output shown?
Which of the following correctly describe steps in the OSI data encapsulation process?
In GLBP, which router will respond to client ARP requests?
Refer to the exhibit． Give this output for SwitchC, what should the network administrator's next action be?
Which layer 2 protocol encapsulation type supports synchronous and asynchronous circuis and has built-in security mechanisms?
Refer to the exhibit． A network administrator attempts to ping Host2 from Host1 and receives the results that are shown． What is a possible problem?
What Netflow component can be applied to an interface to track IPv4 traffic?
While troubleshooting a network connectivity problem, a technician observes steady link lights on both the workstation NIC and the switch port to which the workstation is connected． However, when the ping command is issued from the workstation, the output message "Request timed out．" is displayed． At which layer of the OSI model does the problem most likely exist?
What is known as "one-to-nearest" addressing in IPv6?
What occurs on a Frame Relay network when the CIR is exceeded?
The network administrator is asked to configure 113 point-to-point links．Which IP addressing scheme best defines the address range and subnet mask that meet the requirement and waste the fewest subnet and host addresses?
Refer to the exhibit． Assuming that the router is configured with the default settings, what type of router interface is this?
Refer to the exhibit． Given the output shown from this Cisco Catalyst 2950, what is the most likely reason that interface FastEthernet 0/10 is not the root port for VLAN 2?
Refer to the exhibit． The access list has been configured on the S0/0 interface of router RTB in the outbound direction． Which two packets, if routed to the interface, will be denied? access-list 101 deny tcp 192．168．15．32 0．0．0．15 any eq telnet access-list 101 permit ip any any
What will happen if a private IP address is assigned to a public interface connected to an ISP?