期刊文献+

四角切圆锅炉冷态空气动力场湍流模型研究 被引量:10

Turbulence model of aerodynamic field in cold experimental model for tangential fired boiler
下载PDF
导出
摘要 对自建的冷态四角切圆锅炉模型的空气动力场进行了数值模拟研究,分别采用Standard k-ε、RNGk-ε、Realizable k-ε和雷诺应力(RSM)4种湍流模型计算上一次风、下一次风和三次风的速度分布,并与高精度的PIV试验测量结果进行对比。结果表明,Realizable k-ε模型不仅可以准确分析湍流特性,而且机时消耗较RSM模型大幅减少,其对四角切圆锅炉湍流场的数值模拟研究更具优越性。 Numerical simulation on aerodynamic field of self built cold tangentially fired boiler was conducted.Four turbulence models such as Standard k-ε,RNG k-ε,Realizable k-ε and Reynolds stress model(RSM) were applied to obtain the velocity distribution of the upper primary air,lower primary air and the tertiary air.Moreover,the simulated results were compared with the high-precision PIV(Particle Image Velocimetry) test results.The results showed that,the calculating time of the Realizable k-ε model which can accurately analyze the turbulent characteristics was obviously less than that of the RSM model.
出处 《热力发电》 CAS 北大核心 2013年第2期62-66,共5页 Thermal Power Generation
基金 内蒙古自然基金重大资助项目(20080404ZD07) 内蒙古科技大学创新基金资助项目(2009NC051)
关键词 四角切圆锅炉 冷态试验 空气动力场 PIV测量 湍流模型 tangential fired boiler cold test aerodynamic field PIV measurement turbulence model
  • 相关文献

参考文献7

  • 1Yin C,Caillat S,Harion J L. Investigation of the flow,combustion,heat-transfer and emissions from a 609 MW utility tangentially fired pulverized-coal boiler[J].Fuel,2002.997-1006.
  • 2王小鹏,王志珣,王永旭.炉膛四角切向深度分级气固两相流的数值模拟[J].锅炉制造,2009(2):6-8. 被引量:1
  • 3Zhou Y,Xu T,Hui S. Experimental and numerical study on the flow fields in upper furnace for large scale tangentially fired boilers[J].Applied Thermal Engineering,2009,(4):732-739.doi:10.1016/j.applthermaleng.2008.03.047.
  • 4Choi C R,Kim C N. Numerical investigation on the flow,combustion and NOx emission characteristics in a 500 MW tangentially fired pulverized-coal boiler[J].Fuel,2009.1720-1731.
  • 5Hart J T,Naser J A,Witt P J. Aerodynamics of an isolated slot-burner from a tangentially-fired boiler[J].Applied Mathematical Modelling,2009,(9):3756-3767.doi:10.1016/j.apm.2008.12.020.
  • 6Modlinski N. Computational modeling of a utility boiler tangentially-fired furnace retrofitted with swirl burners[J].Fuel Processing Technology,2010,(11):1601-1608.
  • 7苟湘,周俊虎,周志军,杨卫娟,刘建忠,岑可法.三次风对四角切圆锅炉燃烧和NO_x排放的影响[J].中国电机工程学报,2008,28(8):7-12. 被引量:16

二级参考文献25

  • 1丁宁,曹欣玉,杨亮,赵凯,周志军,周俊虎,刘建忠,岑可法.高长宽比六角切向锅炉缺角流场试验与数值模拟[J].中国电机工程学报,2005,25(1):152-157. 被引量:10
  • 2姜秀民,崔志刚,马玉峰,王辉,张超群.670t/h四角切圆锅炉反切消旋的数值模拟和工程实践[J].中国电机工程学报,2005,25(18):109-115. 被引量:13
  • 3张鼓锋.国家电力公司科学技术课题可行性研究报告.河南电力公司,2000.
  • 4姚强教授.NOx的产生机理及排放控制技术.清华大学煤清洁燃烧国家工程研究中心,2004.
  • 5范贤振,郭烈锦,高晖,聂剑平.200MW四角切向燃烧煤粉炉炉内过程的数值模拟,2002.
  • 6LuisI D, Cristobal C, Antonio C. Modelling of pulverized coal boilers: review and validation of on-line simulation techniques [J]. Applied Thermal Engineering, 2005, 25(10): 1516-1533.
  • 7Kurose R, Makino H, Suzuki A. Numerical analysis of pulverized coal combustion characteristics using advanced low-NOx bumer[J]. Fuel, 2004, 83(6): 693-703.
  • 8Yin Chungen, Caillat S, Harion J L, et al. Investigation of the flow, combustion, heat-transfer and emissions from 609MW utility tangentially fired pulverized-coal boiler[J]. Fuel, 2002, 81(8): 997-1006.
  • 9Jones J M, Patterson P M, Pourkashanian M, et al. Approaches to modelling heterogeneous char NO formation/destruction during pulverisedcoalcombusfion[J]. Carbon, 1999, 37(10): 1545-1552
  • 10Megalos N P, Smith N L, Zhang D K. The potential for low NOx from a precessing jet burner of coal[J]. Combustion and Flame, 2001, 124(1): 50-64.

共引文献15

同被引文献66

引证文献10

二级引证文献37

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部