期刊文献+

扁管结构对平行流冷凝器制冷剂侧性能的影响 被引量:17

Fiat tube structure on refrigerant-side performance of parallel flow type condenser
下载PDF
导出
摘要 平行流冷凝器是一种新型高效紧凑式换热器,其在家用空调器中的应用还存在一些问题,如压降太大等,本文使用Yang和Webb推荐的扁管侧经验传热系数及摩擦阻力关联式,采用数值模拟的方法,研究了家用空调器中平行流冷凝器多孔扁管结构对其传热及压降性能的影响。结果表明:适当减小平行流冷凝器的扁管内孔高度、宽度、宽高比及扁管孔数,可提高其传热系数、增加压降。研究结果为家用空调器中平行流冷凝器多孔扁管参数的选取提供了理论依据。 Parallel flow condenser is a new type of higher and compact heat exchanger,its application in domestic air conditioner still has some problems to be unsolved.Yang & Webb's recommended correlations of heat transfer and friction coefficients were employed in this paper to simulate and study the influence of flat tube structure on heat transfer and pressure drop performance.The result shows that reducing the number of flat tube inner hole,inner hole width,inner hole height,or the aspect ratio will raise the refrigerant-side heat transfer coefficient and pressure drop.The result provides a theoretical basis for selection of flow parallel flat tube parameters for the domestic air conditioner condenser.
出处 《化工学报》 EI CAS CSCD 北大核心 2008年第S2期129-133,共5页 CIESC Journal
基金 广东省教育部产学研结合项目(2007A090302115) 粤港关键领域重点突破项目(佛山专项)(2007Z41) 华中科技大学能源与动力工程学院科学研究基金项目(NK200706)~~
关键词 家用空调器 扁管 传热系数 压降 domestic air conditioner flat tube heat transfer coefficient pressure drop
  • 相关文献

参考文献7

  • 1阚杰,郝亮,李涛,李强,袁秀玲,董晓俊.R404A和R410A应用于平行流冷凝器的模拟分析比较[J].制冷与空调,2007,7(1):56-60. 被引量:3
  • 2包涛,董玉军,周翔,胡跃明,袁秀玲,郭凯.水源热泵系统的稳态模拟与实验研究[J].制冷与空调,2004,4(4):57-60. 被引量:4
  • 3L ee G H,,Y oo J Y.Perform ance ana lys is ands im u lation of au tom ob ile a ir cond ition ing system. In ternationa l Journa l of R efrigeration . 2000
  • 4Shizuo Saitoh Hirofumi Daiguji and Eiji Hihara.Effect of tube diameter on boiling heat transfer of R-134a in horizontal small-diameter tubes. International Journal of Heat and Mass Transfer . 2005
  • 5Schlager L M,Pate M B,Bergles A E.Heat transfer and pressure drop during evaporation and condensation of R22 in horizontal micro-fin tubes. International Journal of Refrigeration . 1989
  • 6Yang C Y,Webb R L.Condensation of R-12 in small hydraulic diameter extruded aluminum tubes with and without microfins. International journal of heat and mass transfer . 1996
  • 7YANG C Y,WEBB R L.Friction pressure drop of R-12 in small hydraulic diameter extruded aluminum tubeswith and without micro-fins. International Journal ofHeat and Mass Transfer . 1996

二级参考文献6

  • 1吴业正.制冷原理与设备(第2版).西安:西安交通大学出版社,1997.
  • 2丁国良,张春路.制冷空调装置智能仿真.北京:科学出版社,2002.
  • 3Yan Yiyie,Lin Tingfa.Condensation heat transfer and pressure drop of refrigerant R-134a in a small pipe.International Journal of Heat and Mass Transfer,1999,42:697-708.
  • 4Ould Didi M B,Kattan N,Thome J R.Prediction of two-phase pressure gradients of refrigerants in horizontal tubes.International Journal of Refrigeration,2002,25:935-947.
  • 5Yang C Y,Webb R L.Friction pressure drop of R-12in small hydraulic diameter extruded aluminum tubes with and without micro-fins.International Journal of Heat and Mass Transfer,1996,39:801-809.
  • 6阙雄才,陈江平.汽车空调使用技术.北京:机械工业出版社.

共引文献5

同被引文献79

引证文献17

二级引证文献53

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部