期刊文献+

6KW柴油发电机组振动性能的有限元分析 被引量:4

Finite Elements Analysis on Vibration Performances of 6 KW Diesel Generator Set
下载PDF
导出
摘要 以额定转速为2 400 r/min,额定功率6 KW柴油发电机组为试验样机,对带有橡胶隔振器的机组振动性能进行研究。采用有限元法得到了机组的固有特性和振动响应,分析了隔振器参数变化对机组振动性能的影响。结果表明:隔振器橡胶杨氏模量和阻尼系数增大到一定数值后,对机组的振动起到良好的抑制作用,隔振器两端的振动差距部分缩小,其它呈增大趋势。 Vibration properties of diesel generator set with a rubber isolator were investigated,which has a power of6 KW and rated speed of 2 400 r / min. Inherent characteristics and dynamic response of the units have been acquired by finite element method( FEM). The influence of different parameters of isolator on vibration properties of diesel generator set was analyzed. The results show that when the Young's modulus and damping coefficient of the rubber isolator increase to a certain value,vibration amplitudes of the units are inhibited well. Except this,vibration gap at both ends of isolator is narrowed in part,and the other trends to increase.
出处 《机械科学与技术》 CSCD 北大核心 2015年第2期173-178,共6页 Mechanical Science and Technology for Aerospace Engineering
关键词 柴油发电机组 振动 隔振器 有限元 acceleration computer simulation computer software damping diesel generator set finite element method isolator mesh generation modal analysis schematic diagrams velocity vibration analysis vibrations(mechanical)
  • 相关文献

参考文献16

二级参考文献23

  • 1俞明,蔡锐彬,陈暹.内燃机机体动态分析有限元模型的建立[J].华南理工大学学报(自然科学版),1996,24(9):107-113. 被引量:4
  • 2马文华,程绍桐.CY6102柴油机机体有限元静态计算分析[J].内燃机工程,1989,10(1):8-13. 被引量:5
  • 3元成浩.CA6102型发动机气缸体三维有限元分析[J].汽车技术,1993(6):9-13. 被引量:8
  • 4李欣欣,卢全国,程光明,杨志刚,王忠伟.压电型步进式精密直线驱动器的试验研究[J].压电与声光,2005,27(2):136-138. 被引量:4
  • 5Ostachowicz W M, Krawczuk M. Analysis of the effect of cracks on the natural frequencies of a cantilever beam [ J]. Journal of Sound and Vibration, 1991,150(2) :191 -201.
  • 6Ismail F, et al. Identification of fatigue cracks from vibration tesring [ J]. Journal of Sound and Vibration, 1990,140(2).
  • 7Wauer J. Vibrations of cracked rotating blades [ J]. Machine Vibration, 1992,(1) :126 -131.
  • 8Cam E, et al. An analysis of cracked beam structureusing impact echo method [J]. NDT & E International, 2005,38.
  • 9Dado M H A. Comprehensive crack identification algorithm for beams under different end conditions [ J]. Applied Acoustics, 1997,51 (4) :381 -398.
  • 10Ford D M, Hayes P A, Smith S K.Engine noise reduction by structural design using advanced experimental and finite element methods.SAE 790366.

共引文献27

同被引文献17

引证文献4

二级引证文献3

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部