期刊文献+

MB3镁合金固态塑性连接组织性能研究 被引量:7

Study on Microstructure and Mechanical Properties of Solid-Phase Joined MB3 Magnesium Alloy
下载PDF
导出
摘要 研究了 MB3 镁合金的搅拌摩擦焊技术。对其塑性连接时的焊缝成形,焊缝组织形态及接头的力学性能进行了分析。结果表明,用搅拌摩擦焊方法焊接 MB3 镁合金,当工艺参数合适时,可获得外观成形美观、内部无缺陷,几乎无变形的平板对接接头。接头力学性能试验表明,其抗拉强度可达母材的 97.2%,高于熔焊接头的强度,断裂位置大多位于热影响区。 Friction stir welding (FSW) is a new solid-phase plastically joining process development in the beginning of the 1990's. In this paper, an investment was carried out on the FSW of MB3 magnesium alloy. An excellent weld appearance, without void, cracking, or distortion was obtained when the welding parameters were carefully chosen. The mechanical property results shown that maximum joint tensile strength can reach 97.2% of the parent material. This is stronger than that of fusion joints, and the failure locations are almost at the heating affected zone.
出处 《稀有金属材料与工程》 SCIE EI CAS CSCD 北大核心 2004年第12期1344-1346,共3页 Rare Metal Materials and Engineering
基金 陕西省科技厅科技计划项目(2003K07-G8) 西安市科技局攻关项目(GG04063)
关键词 搅拌摩擦焊 镁合金 组织形态 力学性能 friction stir welding magnesium alloy microstructure mechanical properties
  • 相关文献

参考文献5

  • 1YanFeng(严峰)etal.稀有金属材料与工程,2003,32(8):16-16.
  • 2C J D. Causing A Stir in Welding Circles[J].Welding & Joining,1999,(4):28
  • 3Johnson M R. Friction Stir Welding Takes off at Boeing[J]. Welding & Joining, 1999,(2): 122
  • 4Hassan Kh A A et al. Stability of Nugget Zone Grain Structures in High Strength Al-Alloy Friction Stir Welds During Solution Treatment[J]. Acta Material, 2003,51:1 923~1 936
  • 5Colligan K. material Flow Behavior During Friction Stir Welding of Aluminum[J]. Welding Journal, 1999, (13): 14~ 16

同被引文献73

引证文献7

二级引证文献75

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部