摘要
对橡胶注射过程中的压力变化进行了理论与实验研究。充模流动模型的压力、能量控制方程分别为：选用高斯方法求解总体有限元方程。实验与计算分析对比证明．本文选用的数学模型和计算方法所得结果与实测结果基本吻合、该模型可用以代替大量的实验，对橡胶充模过程进行模拟，并用Ｇｒａｐｈｅｒ软件对数值结果进行处理，以图表直观地表达出各种因素对充模过程的影响。
An investigation was made theoretically and experimentally on the pressure variation in rubber injection moulding. The pressure and energy control equations in the filling flowmodel were as follows. TheGaussian method was used to solve the general finite element equation. It was showed through thecomparative analysis that the results obtained with the selected mathematical model and calculation method were approximate to the measured ones. The proposed model could be used instead ofa large number of tests to simulate the rubber filling process. The resultant values were treatedwith Grapher software. The influence of various factors on the filling process was expressed directly by figures and tables.
出处
《橡胶工业》
CAS
北大核心
1996年第7期387-396,共10页
China Rubber Industry
关键词
橡胶
注塑成型
压力
成型
rubber injection moulding,injection moulding pressure
