摘要
以渤海某稠油油田原油、采出水和驱油用聚合物为基础,借鉴陆地类似油田产出聚合物的变化情况,结合油田实际产出物,配制了模拟产出物。制备了一种破乳剂,考察了破乳剂、聚合物、水相体积比例、温度、矿化度、pH值、剪切强度、粒子含量、溶剂和其它药剂等因素对破乳性能的影响和电脱水,并进行了现场评价。
On the basis of one heavy oil, the production water and polymer for polymer flooding in Bohai oilfield, the produced fluids were simulated according to the produced fluids of the onshore oilfield. The demulsi fiers were prepared, and effects of demulsifiers, polymers, water volume percentage of produced fluid, temperature , salinity, pH, shear strength, solid particle content, solvent and other water handling chemicals on demulsification were investigated. Additionally, the electrical dehydration and on - site tests were conducted. It was shown that water cut of crude oil was less than 1 % when the polymer AP - P4 concentration was 110 mg/L.
出处
《石油与天然气化工》
CAS
CSCD
北大核心
2006年第2期130-133,共4页
Chemical engineering of oil & gas
基金
国家863项目"渤海油田深部调剖提高采收率技术研究"(编号2001AA602014)。
关键词
稠油
聚合物驱油
破乳
脱水
原油含水率
heavy oil, polymer flooding, demulsifi cation, dewatering, water cut of crude oil
