期刊文献+

二维C/SiC复合材料的铆接显微结构与性能研究 被引量:6

Microstructure and Properties of Joints of 2D C/SiC Composites by Riveting
下载PDF
导出
摘要 将直径为2.5mm,3.4mm,4.5mm,6mm,8mm的2DC/SiC复合材料铆钉和尺寸为φ12.8mm×6.5mm带孔件进行紧配合装配,然后对其沉积SiC,沉积时间300h,最终实现铆接。采用扫描电镜(SEM)及拉伸试验来测试连接情况。结果表明:当铆钉直径小于4.5mm时发生铆钉断裂现象,接头为脆性破坏;当直径大于4.5mm时发生铆钉拔出现象,接头为韧性破坏。但是直径越大被连接复合材料的性能损失越大,因此最佳的铆钉尺寸应稍大于4.5mm。 The 2D C/SiC composites in dimension of φ12.8mm×6.5mm^3, were assembled with rivets with diameters of 2.5 mm, 3.4 mm, 4.5 mm, 6 mm, 8 mm respectively and infiltrated with SiC for 300 h. The results of scanning electron microscopy (SEM) and tensile tests, show that the fracture of the rivet took, place, and the joint presented brittle fracture when the rivet diameter was less than 4.5 mm. Pulling out of the rivet took place, and the joint presented graceful fracture when the rivet diameter was bigger than 4.5 mm. The bigger the rivet diameter, the worse the properties of composite. Therefore the optimal rivet dimension should be slightly bigger than 4.5 mm.
出处 《稀有金属材料与工程》 SCIE EI CAS CSCD 北大核心 2006年第9期1497-1500,共4页 Rare Metal Materials and Engineering
基金 国家自然科学基金(50272053) 西北工业大学校重点扶持项目资助
关键词 C/SIC 复合材料 铆接 C/SiC composite riveting
  • 相关文献

参考文献5

  • 1Tong Qiaoying,Chen Laifei,Zhang Litong.Journal of Aeronautical Materials[J],2004,24(1):53
  • 2Nakamura M,Shigemastu I.Journal of Material Science[J],1996,(31):6099
  • 3Sherwood W J.Cermic Engineering and Science Proceedings[J],1997,18(3A):177
  • 4Sinh M.Key Eng Mater[J],1999,(164~165):415
  • 5TongQiaoying(童巧英) ChenLaifei(成来飞) ZhangLitong(张立同).稀有金属材料与工程,2004,33(2):101-101.

同被引文献73

  • 1张立同,成来飞,徐永东,刘永胜,曾庆丰,董宁,栾新刚.自愈合碳化硅陶瓷基复合材料研究及应用进展[J].航空材料学报,2006,26(3):226-232. 被引量:46
  • 2于水生,卢玉斌,蔡勇.工程材料的应变率效应及其统一模型[J].固体力学学报,2013,34(S1):63-68. 被引量:12
  • 3袁秦鲁,李玉龙,李贺军,李淑萍,郭领军.C/C复合材料压缩破坏的应变率效应研究[J].无机材料学报,2007,22(2):311-314. 被引量:11
  • 4张立同,成来飞.连续纤维增韧陶瓷基复合材料可持续发展战略探讨[J].复合材料学报,2007,24(2):1-6. 被引量:209
  • 5Raman V, Blaatia G, Mishra A, et al. Development of carbon- ceramic composites[J]. Materials Science and Engineering A, 2005, 412(1/2): 31-36.
  • 6Nicholas M G, Peteves S D. Reactive joining: Chemical effects on the formation and properties of brazed and diffusion bonded interfaces[J]. ScriptaMaterial, 1994, 31(8): 1091-1096.
  • 7Loehman R E. Recent progress in ceramic ioining [J].Key Engineering Material, 1999, 161-163: 657-662.
  • 8Santeila M L. A Review of techniques for ioining advanced ceramics[J]. American Ceramic Society Bulletin, 1992, 71 (6) : 947-954.
  • 9Cawley J D. Joining of ceramic- matrix composites [J]. American Ceramic Society Bulletin, 1989, 68(9) : 1619-1623.
  • 10Salvo M, Lemoine P, Ferrarix M, et al. Joining of carbon -carbon composites for thermonuclear fusion applications [J]. Journal of the American Ceramic Society, 1997, 80(1): 206-212.

引证文献6

二级引证文献13

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部