期刊文献+

中国南海深水油气田开发工程模式及平台选型 被引量:93

Engineering mode and platform selection for deepwater oilfield development in South China Sea
下载PDF
导出
摘要 介绍了国外深水油气田开发的状况,对国外典型的深海油田开发工程模式进行了对比分析。根据国内海洋工程资源现状、技术与装备状况以及南海的环境条件,提出了适宜中国南海深水油田开发的工程模式。在此基础上,考察了国际上所应用的不同种类的深水钻井及采油平台,分析了各类平台的结构特点及应用状况,提出了中国南海深水油气田平台结构选型的方案,并探讨了我国深水平台技术研究的重点攻关方向。 The exploration and development of abroad deepwater oilfields were introduced. The most appropriate development mode applicable to deepwater oilfield of the South China Sea was investigated by comparing the current typical engineering modes for deepwater oilfield development in the world according to the actual environmental conditions of the South China Sea, as well as the current and near future technical capability and equipment state of the China National Offshore Oil Corporation. The structures of typical deepwater platforms were analyzed. The selection scheme of deepwater platforms in the South China Sea was suggested. The key technologies for development of deepwater platform in the South China Sea were discussed.
出处 《石油学报》 EI CAS CSCD 北大核心 2007年第1期115-118,共4页 Acta Petrolei Sinica
基金 国家高技术研究发展计划(863)项目"深水油气开发工程共用技术平台的研究"(2004AA617010)资助
关键词 中国南海 深水油气开发 工程模式 钻井船 张力腿平台 半潜式平台 South China Sea deepwater oil-gas development engineering mode drilling platform tension leg platform semi-submersible platform
  • 相关文献

参考文献10

  • 1谢彬,段梦兰,秦太验,孙政策,李杰.海洋深水立管的疲劳断裂与可靠性评估研究进展[J].石油学报,2004,25(3):95-100. 被引量:21
  • 2段梦兰,陈永福,李林斌,张继春,包小兵,周立伟.海洋平台结构的最新研究进展第9届ISOPE大会报告综述[J].海洋工程,2000,18(1):86-90. 被引量:9
  • 3API RP 2T-1997.Recommended practice for planning,designing,and constructing tension leg platforms[S].2nd Edition,Houston:[s.n.],1997.
  • 4Norwegian Technology Standards Institution.NORSOK Standard-1998 Special design provisions for tension leg platforms,design of steel structures[S].Norway:[s.n.],1998.
  • 5Halkyard J E.Status of spar platforms for deepwater production systems:Proceedings of the Sixth (1996)International Offshore and Polar Engineering Conference,LA,USA,May 26-31,1996[C].ISOPE,1996:262-269.
  • 6Wang J,Berg S,Luo Y H,et al.Structural design of the truss spar-an overview:Proceedings of the Eleventh(2001)International Offshore and Polar Engineering Conference,Stavanger,Norway,June 17-22,2001[C].ISOPE,2001:354-361.
  • 7Finn L D,Maher J V,Gupta H.The cell spar and vortex induced vibrations[R].OTC 15244,2003:1-6.
  • 8Gupta H,Finn L,Weaver T.Effects of spar coupled analysis[R].OTC 12082,2000:629-638.
  • 9Colby C.Coupling effects for a deepwater spar[R].OTC 12083,2000:639-645.
  • 10Irani M B,Rouckout T,Johnson R P.Dynamics of a spar platform:Proceedings of the Tenth(2000)International Offshore and Polar Engineering Conference,Seattle,USA,May 28-June 2,2000[C].ISOPE,2000:261-268.

二级参考文献32

  • 1Leira B J,Karunakaran D,Bjorset A.Fracture and fatigue reliability assessment of deep-water risers[R].17th International Conference on Offshore Mechanics and Arctic Engineering,1998:98-1365,1-9.
  • 2Teigen P,Karunakaran D.A consistent approach to riser fatigue analysis including diffraction[R].17th International Conference on Offshore Mechanics and Arctic Engineering,1998:98-1394.
  • 3Buitrago J, Sele A B. Strength and fatigue provisions for mechanical connector design: new ISO standard for offshore structures[R]. 17th International Conference on Offshore Mechanics and Arctic Engineering,1998:98-2501.
  • 4Thorogood J L,Norge B P. Deep water riser system design and management[R]. IADC/SPE 39295, 1998:25-31.
  • 5Buitrago J, Zettlemoyer N. Fatigue design of critical girth welds for deepwater applications[R].17th International Conference on Offshore Mechanics and Arctic Engineering, 1998:98-2004.
  • 6Karunakaran D,Lund K M,Nordsve N T. Steel catenary riser configurations for North Sea field developments[R].OTC 10979,1999:331-338.
  • 7Martins C A,Costa A B,Harada C A N.Parametric analysis of steel catenary risers:fatigue behavior near the touchdown point[R].Proc.of the 9th International Offshore and Polar Engineering Conference,1999,Vol.Ⅱ,314-319.
  • 8Bjorset A,Leiira B J,Remseth S.Local buckling analysis of Titanium pipes by probabilistic response surface methods[R].17th International Conference on Offshore Mechanics and Arctic Engineering,1998:98-1487.
  • 9Berge S.Fatigue strength of Titanium risers:effect of defects[R].17th International Conference on Offshore Mechanics and Arctic Engineering,1998:98-2209.
  • 10Torster F,Santos J F D.Fatigue properties of radial friction welded Ti-6AL-4V-0 1RU risers[R].18th International Conference on Offshore Mechanics and Arctic Engineering,1999:99/MAT-2162.

共引文献28

同被引文献640

引证文献93

二级引证文献730

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部