期刊文献+

表面处理方法对胶粘剂性能的影响 被引量:2

Effect of surface treatment methods on properties of adhesive
原文传递
导出
摘要 采用不同的表面处理方法处理粘接接头,在湿热老化条件下通过元素分析法测定了样品中碳、硅、氧的含量,以及对胶粘剂粘接接头剥离强度、吸水率,玻璃化温度等湿热老化性能进行了考查,得出最佳处理粘接接头的方法。 In this paper,different method of surface treatment was adopted to dispose adhesive joints. In the condition of humidity,the contents of carbon,silicon and oxygen were obtained by elements analysis. Through the research of properties of peel strength,uptake water and glass-transition temperature ,the optimum method in disposing adhesive joints were obtained.
出处 《中国胶粘剂》 CAS 2007年第5期14-16,共3页 China Adhesives
关键词 剥离强度 吸水率 粘接接头 表面处理 peel strength water uptake adhesive joints surface treatment
  • 相关文献

参考文献10

  • 1SUY Y,YEA Y,SHEMENSKI M. A method for continuous monitoring of bend formation between rubber and reinforced wire [J]. International Journal of Adhesion and Adhesives, 2001,21:481-485.
  • 2ROMERO-SANCHEZ,MARIA D,MERCEDES PASTOR- BLAS M ,et al. Addition of ozone in the UV radiation treatment of a synthetic styrene-butadiene-styrene (SBS) rubber [J]. International Journal of Adhesion and Adhesives, 2005,25 : 358-370.
  • 3CARBONE G,MANGIALARDI L. Adhesion and friction of an elastic half-space in contact with a slightly wavy rigid surface[J]. Journal of the Mechanics and Physics of Solids, 2004,52:1 267-1 287.
  • 4PASTOR B M, MARTIN-MARTINEZ J M, BOERIO F J.Influence of chlorinating solution concentration on the interactions produced between chlorinated thermoplastic rubber and polyurethane adhesive at the interface[J]. Journal of Adhesion, 2002,78 ( 1 ) : 39-77.
  • 5PALASANTZAS G. Influence of self-affine roughness on the adhesive friction coefficient of a rubber body sliding on a solid substrate[J]. Surface Science, 2004,565 : 191-196.
  • 6BOUISSOU S,BARQUINS M.Kinetics of adherence of a rigid truncated cone on an elastic half-space (unfilled natural rubber)[J]. International Journal of Adhesion and Adhesives, 2002,22:459-463.
  • 7JANG J,LIM B. Investigation of a fiber-reinforced plastic/ rubber adhesive system using statistical experimental design [J]. Polymer Testing,2001,20:117-123.
  • 8DUNCAN B, DEAN G. Measurements and models for design with modem adhesives [J].Intemational Journal of Adhesion and Adhesives, 2003,23 : 141-149.
  • 9MAEDA K,BISMARCK A,BRISCOE B J. Mechanisms of scratching frictions and damage maps for rubber compounds [J].Wear, 2005,259: 651-660.
  • 10LOH W K,CROCOMBE A D,ABDEL M M,et al. Modelling anomalous moisture uptake,swelling and thermal characteristics of a rubber toughened epoxy adhesive [J]. International Journal of Adhesion and Adhesives, 2005,25 : 1-12.

同被引文献17

引证文献2

二级引证文献15

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部