摘要
Three kinds of Al-11%Si (mass fraction) alloy samples with different processes were produced to investigate the effect of microstructures on its superplasticity. Among them, the as-ECAP sample pressed 16 passes has ultrafine grains (300 nm) and the finest secondary particles. The ECAP-T6 sample, with ECAP 16 passes followed by T6 treatment, has fine secondary particles (3 μm) but the largest grains (8 μm). Contrarily, the T6-ECAP sample, with T6 treatment followed by ECAP 16 passes, has ultrafine grains and the large secondary particles (7 μm). The tensile testing results show that the as-ECAP sample exhibits superplasticity at high strain rate of 5.75×10-1 s-1 due to its fine secondary particles and ultrafine grains. The ECAP-T6 sample, however, does not exhibit superplasticity at the same high strain rate of 5.75×10-1 s-1 because it has relatively large secondary particles and large grains. Remarkably, the T6-ECAP sample does not have superplasticity even at the lower strain rate of 1.15×10-1 s-1, attributing to its comparatively large secondary particles. When most secondary particles are larger than 7 μm, the high strain rate superplasticity could not be obtained even if this sample has ultrafine grains.
Three kinds of A1-11%Si （mass fraction） alloy samples with different processes were produced to investigate the effect of microstructures on its superplasticity. Among them, the as-ECAP sample pressed 16 passes has ultrafine grains （300 nm） and the finest secondary particles. The ECAP-T6 sample, with ECAP 16 passes followed by T6 treatment, has fine secondary particles （3 μm） but the largest grains （8 μm）. Contrarily, the T6-ECAP sample, with T6 treatment followed by ECAP 16 passes, has ultrafine grains and the large secondary particles （7 μm）. The tensile testing results show that the as-ECAP sample exhibits superplasticity at high strain rate of 5.75×10^-1 s^-1 due to its fine secondary particles and ultrafine grains. The ECAP-T6 sample, however, does not exhibit superplasticity at the same high strain rate of 5.75×10^-1 s^-1 because it has relatively large secondary particles and large grains. Remarkably, the T6-ECAP sample does not have superplasticity even at the lower strain rate of 1.15×10^-1 s^-1, attributing to its comparatively large secondary particles. When most secondary particles are larger than 7 μm, the high strain rate superplasticity could not be obtained even if this sample has ultrafine grains.
出处
《中国有色金属学会会刊：英文版》
CSCD
2007年第3期509-513,共5页
Transactions of Nonferrous Metals Society of China
关键词
硅铝合金
微结构
粒子
超塑性能
Al-Si alloy
microstructure
secondary particle size
superplasticity
grain size
metals and alloys
