期刊文献+

晶须状填料对酚醛树脂摩擦材料性能的影响 被引量:18

Effect of Whiskers-like Fillers on the Phenolic Resin-based Friction Material
下载PDF
导出
摘要 研究了分别填充钛酸钾晶须、碳酸钙晶须、针状硅灰石对刹车片摩擦磨损性能的影响。采用MPX-2000和XD-MSM摩擦机对样品进行敏感性和抗热衰退性试验以及定速试验,利用扫描电镜对磨损表面和磨屑进行分析。结果表明,碳酸钙晶须对速度敏感性最低,而钛酸钾晶须对载荷敏感性最低,对速度敏感性最高。钛酸钾晶须的摩擦因数稳定在0.29-0.35,衰退率仅为10%,而碳酸钙晶须和针状硅灰石在250℃后,衰退率高达36%和51%。钛酸钾晶须的磨损率变化平稳,高温段仅是碳酸钙晶须的1/4,针状硅灰石的1/6。钛酸钾晶须有利于形成平整摩擦面,但碳酸钙晶须和针状硅灰石易带来表面磨损。 The effects of potassium titanate whiskers and calcium carbonate whiskers and needle-like wollastonite on the tribological properties of braking friction material were studied. Low temperature tests for speed and load sensitivity measurements and high temperature tests at a constant interval mode to measure fade were evaluated on MPX-2000 tester. Their tribological behaviors were examined on a friction tester with fixed velocity. Morphologies of the worn surfaces and the worn debris were observed by scanning electron microscopy. The results reveal that friction materials filled with calcium carbonate whiskers have the lowest sensitivities to the velocity and potassium titanate whiskers have the lowest sensitivities to the load and the highest sensitivities to the velocity. The friction coefficient of potassium titanate whiskers ranges within 0. 29 - 0. 35 and fade rate is only 10%. Calcium carbonate whiskers and needle-like wollastonite experience serious fade phenomenon above 250 ℃. The fad rates of them are 36% and 51% respectively. The wear rate of potassium titanate whiskers has little fluctuation in the experiment,which is 1/4 of the wear rate of calcium carbonate whiskers and 1/6 of needle-like wollastonite in the high temperature region. Potassium titanate whiskers increase the smooth of friction surface. But calcium carbonate whiskers and needle-like wollastonite lead to the formation of rough rubbing surface.
出处 《润滑与密封》 CAS CSCD 北大核心 2007年第11期122-126,共5页 Lubrication Engineering
基金 国家科技支撑计划重点项目(2006BAE03B07)
关键词 碳酸钙晶须 针状硅灰石 钛酸钾晶须 摩擦磨损 刹车片 calcium carbonate whiskers needle-like wollastonite potassium titanate whiskers friction and wear brake pad
  • 相关文献

参考文献14

  • 1G Yi,F Yan.Mechanical and tribological properties of phenolic resin-based friction composites filled with several inorganic fillers[J].Wear,2007,262:121-129.
  • 2J Bijwe.Composites as friction materials:Recent developments in non-asbestos fiber reinforced friction materials-A review[J].Polymer Composites,1997,18(3):378-396.
  • 3K W Hee,P Filip.Performance of ceramic enhanced phenolic matrix brake lining materials for automotive brake linings[J].Wear,2005,259:1088-1096.
  • 4S J Kim,M H Cho,D S Lim,et al.Synergistic effects of aramid pulp and potassium titanate whiskers in the automotive friction material[J].Wear,2001,250:1484-1491.
  • 5Komatsu,Masato.Asbestos-free composite friction materials:JP05105867[P].
  • 6沈上越,李珍,宋旭波,张德,胡珊,刘新海.两种纤维状矿物作为汽车刹车片增强材料的实验研究[J].摩擦学学报,2003,23(3):253-257. 被引量:11
  • 7陆小华 暴宁钟 冯新 等.六钛酸钾晶须及纤维的制造方法[P].中国专利:99114005.2.19990-01-07.
  • 8QC/T 556-1999汽车制动器温度测量和热电偶安装[S].
  • 9H Jang,K Ko,S J Kim,et al.The effect of metal fibers on the friction performance of automotive brake friction materials[J].Wear,2004,256:406-414.
  • 10Y C Kim,M H Cho,S J Kim,et al.The effect of phenolic resin,potassium titanate,and CNSL on the tribological properties of brake friction materials[J].Wear,2007,doi:10.1016/j.wear.2007.03.004.

二级参考文献9

  • 1杨鸥.Topic of Chinese Asbestos and Health(中国的石棉与健康话题)[J].Chinese Asbestos Product(中国石棉制品),2001,(3):88-90.
  • 2张德林.盘式制动片摩擦性能测试方法[A].汽车摩擦材料情报网编.摩擦材料论文集[C].,1993.315~319.
  • 3Bark L S. Polymer changes during friction material performance.Wear, 1997 (41): 19-25.
  • 4Day A J. The dissipation of frictional energy from the interface of a annular discbrake. Proce Int Mech Engrs, 1998 ( 11 ) : 201-209.
  • 5Bark L S. Chemical changes in asbestos base friction material during performance. Wear, 1995 (34): 345-348.
  • 6New T P. Cooling rates of brake drums and disc proce. Auto Div Instn Mech Engrs, 1996 (6): 1111-1114.
  • 7谢关烜,丰向军.摩擦工作表面温度的有限元分析[J].锻压机械,1989,24(2):33-35. 被引量:8
  • 8马保吉,朱均.紧急制动过程动态摩擦热源模型[J].机械科学与技术,1998,17(5):698-700. 被引量:4
  • 9马保吉,韩莉莉,朱均.盘式制动器的温度场分析[J].西安工业学院学报,1998,18(4):311-315. 被引量:8

共引文献33

同被引文献203

引证文献18

二级引证文献95

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部