期刊文献+

小麦秸秆颗粒燃料冷态压缩成型参数试验研究 被引量:30

EXPERIMENTAL RESEARCH ON THE COMPRESSING MOLDING PARAMETER UNDER COLD CONDITIONS FOR WHEAT STRAW PELLET FUEL
下载PDF
导出
摘要 对小麦秸秆进行了不同含水率、压缩速度、模具长径比及开口锥度等不同条件下的冷态压缩成型试验,分析了压缩成型过程包括松散、过渡、压紧和推移4个阶段,不同阶段产生物料变形的原因各不相同。通过对试验结果进行分析,得出结论为:压缩速度取40mm/min时,能够保证较高的最大压缩密度和较低的比能耗;当含水率取16%、模具长径比为5.2、开口锥度为45°时成型效果最佳。 The cold ompressing molding experiments of wheat straw with different water ration, compressing speed, length to diameter ratio of the mold, placket taper were done in the paper. And the compressing process was analysed, including loose, transition, compaction and motion. The reasons for distortion of the material are different in different stage. The following conclusion was educed from the results, maximum compressing density and fairly low energy consuming could be ensured with the compressing speed of 40mm/min, and molding result was the best with water ratio of 16%, ratio of length to diameter for mold 5.20 and placket taper of 45°.
出处 《太阳能学报》 EI CAS CSCD 北大核心 2008年第2期241-245,共5页 Acta Energiae Solaris Sinica
基金 河南省自然科学基金项目(0611021100)
关键词 冷态成型 含水率 压缩速度 最大压缩密度 模具长径比 开口锥度 molding under cold conditions water ratio compressing speed maximum compressing density ratio of length to diameter for the mold placket taper
  • 相关文献

参考文献8

  • 1何晓峰,雷廷宙,李在峰,朱金陵.生物质颗粒燃料冷成型技术试验研究[J].太阳能学报,2006,27(9):937-941. 被引量:57
  • 2盛奎川,吴杰.生物质成型燃料的物理品质和成型机理的研究进展[J].农业工程学报,2004,20(2):242-245. 被引量:126
  • 3盛奎川,钱湘群,吴杰.切碎棉杆高密度压缩成型的试验研究[J].浙江大学学报(农业与生命科学版),2003,29(2):139-142. 被引量:30
  • 4Grover P D, Mishra S K. Proceedings of the international workshop on biomass briqueting[J]. New Delhi, India, 1996.
  • 5O' dogherty M J. A review of the mechanical behaviour of strew when compressed to high densities [ J ]. J Agric Engng Res, 1996,44: 241-265.
  • 6O' Dogherty M J, Wheeler J A. Compression of straw to high densities in closed cylindrical dies[J]. Journal of Agriculture Engineering Research, 1984,29(1) :61-72.
  • 7Faborode M O, Callaghan J R. Theoretical analysis of the compression of fibrous agricultural materials [ J]. Journal of Agricultural Engineering Research, 1986,35(3) : 175-191.
  • 8Butler J L. Energy comparisons in processing coastal bermuda grass and alfalfa[J]. Transactions of American Society of Agricuhural Engineers, 1985,8(2) : 175-179.

二级参考文献34

共引文献192

同被引文献273

引证文献30

二级引证文献220

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部