期刊文献+

室内火灾区域模拟烟气羽流模型的适用性 被引量:21

Applicability of the Plume Models for the Zone Modeling of the Smoke in Compartment Fires
下载PDF
导出
摘要 结合不同的烟气羽流模型与门口溢流模型,对室内火灾过程进行建模,利用区域模拟方法计算室内热烟气层厚度及温度随时间的变化情况.利用ISO 9705全尺寸标准火灾实验系统进行实验研究,通过计算结果与实验结果的比较,分析不同羽流模型的适用性.结果表明:Thomas模型与McCaffrey模型预测的羽流流量值偏大,导致烟气温度计算值比实验值偏低,不适用于大功率火源的情况;Zukoski模型预测的羽流卷吸量偏低,其温度计算值比实验值偏高,适合于小功率火源的情况;Heskestad模型预测的羽流流量值较为稳定,区域模拟结果与实验符合得较好,可用于大功率火灾羽流的预测. With different plume and spill plume correlations, a simple model was built to describe compartment fires. The zone method was used to calculate the temperature and thickness of hot smoke in compartment fires. The corresponding experiments were performed with the ISO 9705 full-scale standard fire experimental system. The applicability of the different plume models was analyzed on the basis of the comparison between the calculated results and the experimental data. The results demonstrated that the Thomas model and McCaffrey model predicted a greater plume flow, which caused a lower calcu-lated smoke temperature, so they are inapplicable to large power fires. The plume flow predicted by the Zukoski model was smaller, and the calculated temperature was higher than the measured one, so it is more applicable to small power fires. The plume flow predicted by the Heskestad model was steady, and the result of the zone simulation agreed well with the experimental data, so it could be used to predict large power fires.
作者 陈长坤 姚斌
出处 《燃烧科学与技术》 EI CAS CSCD 北大核心 2008年第4期295-299,共5页 Journal of Combustion Science and Technology
基金 国家自然科学基金资助项目(50706059) 河南省煤矿瓦斯与火灾防治重点实验室开放基金资助项目(HKLGF200503) 国家自然科学基金重大国际合作资助项目(50320120156)
关键词 区域模拟 羽流模型 火灾 烟气 zone modeling plume model fire smoke
  • 相关文献

参考文献8

  • 1Heskestad G. Engineering relations for fire plumes [ J ]. Fire Safety Journal, 1984, 7(1): 25-32.
  • 2Thomas P H, Hinkley P L, Theobald C R, et al. Investigations into the Flow of Hot Gases in Roof Venting, Fire Research Teeh Paper 7 [Z]. London: HMSO, 1963.
  • 3Zukoski E E, Kubota T, Cetegen B. Entrainment in fire plumes [J]. Fire Safety Journal, 1981, 3(2): 107-121.
  • 4McCaffrey B J. Momentum implications for buoyant diffusion Flames [ J ]. Combustion and Flame, 1983, 52 (2) : 149-167.
  • 5史聪灵,霍然,李元洲,彭伟,姚斌.火灾环境下钢构件升温过程的模型研究[J].中国工程科学,2003,5(12):66-72. 被引量:9
  • 6ISO 9705. Fire Tests Full-Scale Room Test for Surface Products [ S ]. Geneva: International Standards Organization ISO), 1993.
  • 7杨昀,张和平,徐亮,王蔚,朱五八.标准单室内单人沙发全尺寸火灾实验研究[J].燃烧科学与技术,2004,10(5):423-427. 被引量:11
  • 8Drysdale D. An Introduction to Fire Dynamics-Second Edition [M]. London: John Wiley and Sons, 1999.

二级参考文献8

  • 1Ogle R A, Schumacher J L. Fire patterns on upholstered furniture: Smoldering versus flaming combustion[J]. Fire Technology, 1998, 34(3) :247-265.
  • 2Sundstrom B. CBUF fire safety of upholstered furniture-the final report on the CBUF research programme[R]. European Commission Measurements and Testing, Report EUR 16477 EN, Interscience Communication Ltd, London,1995.
  • 3Vytenis Babrauskas, Djebar Baroudi, Jukka Myllymaki, et al. The cone calorimeter used for predictions of the full-scale burning behavior of upholstered furniture[J]. Fire and Materials, 1997, 21:95-105.
  • 4ISO 9705. Fire Tests-Full Scale Room Test for Surface Products[S]. International Standards Organization (ISO),Geneva, 1993.
  • 5Huggett C. Estimation of rate of heat release by means of oxygen consumption measurements[J]. Fire and Materials,1980,4: 61-65.
  • 6Babrauskas V, Grayson S J. Heat Release in Fires [M].Elsevier Applied Science London and New York: Library of Congress Catalogue-in-Publication Data, 1992.
  • 7Drysdale D. An Introduction to Fire Dynamics[M]. London: John Wiley & Sons, 1987. 58.
  • 8霍然,李元洲,金旭辉,范维澄.大空间内火灾烟气充填研究[J].燃烧科学与技术,2001,7(3):219-222. 被引量:40

共引文献16

同被引文献143

引证文献21

二级引证文献46

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部