期刊文献+

宽厚板坯连铸中间罐内钢液流动特性分析 被引量:1

Characteristics analysis of molten steel flow in a wide and thick slab continuous casting tundish
下载PDF
导出
摘要 结合一宽厚板坯单流连铸中间罐的物理模拟,应用两个组合模型对比分析了中间罐内流体流动特性,并考察了不同控流装置对中间罐内流动特性的影响.结果表明:两个组合模型在死区体积分数的计算上存在较大差别,本实验中的两者最大相差74.6%,传统的组合模型会对中间罐内流动特性的判断及优化方案的选择造成较大的偏差,而修正后的混合模型因对死区体积分数的计算的合理修正,可用来准确分析单流中间罐内流体的流动特性.本文通过实验研究提出了中间罐流场优化方案. By means of the measured results in a physical model for a wide plate single - strand tundish, two combined models for characterizing the melt flow were compared, and the effect of different control devices on fluid flow behaviour was also studied. The result shows that there is a big difference between these two models for the calculation of dead volume fraction and the maximal difference reaches 74. 6% in the present experiment. The traditional model may make mistakes both in the estimation on the melt flow characterization and in the choice of optimal flow control devices. As a reasonable modification has been made on the calculation of dead volume fraction, the modified combined model is suitable for characterizing the melt flow in single - strand tundish. In present study, an optimal proposal is presented through the physical modeling study.
出处 《材料与冶金学报》 CAS 2008年第4期254-257,共4页 Journal of Materials and Metallurgy
关键词 宽厚板坯连铸中间罐 流动特性 分析模型 物理模拟 wide and thick slab continuous casting tundish melt flow analysis model physical modeling
  • 相关文献

参考文献15

二级参考文献39

  • 1詹树华,欧俭平,萧泽强.连铸中间包底吹气过程水模型实验研究[J].中南大学学报(自然科学版),2004,35(6):960-964. 被引量:13
  • 2南晓东.第三炼钢厂板坯连铸中间包的水力学模拟[J].首钢科技,1994(3):23-26. 被引量:2
  • 3顾武安,杨素波,礼重超.攀钢连铸中间包水力模型实验[J].钢铁钒钛,1995,16(3):30-33. 被引量:4
  • 4张先棹.冶金传输原理[M].北京:冶金工业出版社,1988.438,432.
  • 5冶金报社.连续铸钢500问[M].北京:冶金工业出版社,1994.153-175.
  • 6田智勇.新型镁钙质中间包涂料的使用.钢铁,1997,:666-669.
  • 7[3]高允彦.正交及回归试验研究方法.第二版.北京:冶金工业出版社,1988.213.
  • 8Sahay S K,De T K,Basu D S , Mazundar S. Strand Performance Improvement Through Use of Asymmetric Baffles in Tundish of Six Strand Billet Caster at DSP[J].Iron and Steel, 2001, (7):71-74.
  • 9Mazumdar D, Guthrie R I L.The Physical and Mathematical Modehng of Continuous Casting Tundish System[J].ISIJ International, 1999,39(6): 524-528.
  • 10Bao Yanping,Xu Bomei, Liu Guolin, Yue Feng, Qi Xinxia. Design Optimization of Flow Control Device for Multi-strand Tundish [J].Journal of University of Science and Technoloy, 2003,10(2):21-24.

共引文献46

同被引文献7

引证文献1

二级引证文献2

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部