期刊文献+

AOD炉蓄热式烘烤过程的数值模拟研究 被引量:3

Numerical Simulation of Regenerative Baking Process in AOD
下载PDF
导出
摘要 为研究新型蓄热式AOD炉烘烤器的烘烤效果,对AOD炉烘烤过程的流动、燃烧、传热现象进行数值模拟研究,定量考察了空-燃比、空气预热温度、天然气流量等烘烤工艺参数对炉衬温度的影响规律。结果表明,增加天然气流量和空气预热温度是提高炉壁温度的有效措施,空-燃比变化对温度的影响较小;应用蓄热式AOD炉烘烤器,在满足烘烤温度1 373 K的基础上,温差基本可以控制在50 K以内,烘烤温度均匀性较好。提出了供现场参考的烘烤工艺参数。 In order to study the effect of the new regenerative baker for AOD (Argon and Oxygen Decarburization), numerical simulation of gas flow, combustion and heat transfer in AOD during the baking process has been carried out. The influences of air-fuel ratio, preheated air temperature anti nature gas flux on the lining temperature of AOD after baking are quantitatively analyzed. Results show that raising the flux of nature gas and preheated air temperature are effective measures to increase the lining temperature, while the influence of air-fuel ratio on the lining temperature is relatively small. With the regenerative AOD baker, the lining temperature can reach the desired temperature 1 373 K, and the temperature difference can maintain lower than 50 K, that shows a good uniformity for the temperature. In addition, the optimal baking parameters for the actual performance were presented.
出处 《工业加热》 CAS 2008年第6期39-42,共4页 Industrial Heating
关键词 蓄热式烘烤器 数值模拟 炉衬温度 AOD regenerative baker numerical simulation lining temperature AOD
  • 相关文献

参考文献6

二级参考文献44

  • 1朱彤,吴家正,冯良,张鹤声.高温空气低燃气浓度燃烧过程的数值模拟研究[J].工程热物理学报,2005,26(z1):277-279. 被引量:9
  • 2郭震,贾恩宝.蓄热式燃烧技术在钢包烘烤器上的应用[J].工业炉,2005,27(3):27-28. 被引量:5
  • 3朱大奇,王红.钢包烘烤的温度控制系统[J].电子与自动化,1996,25(4):16-18. 被引量:2
  • 4孙国宏.浅谈蓄热式燃烧技术及其发展前景[J].中国科技信息,2005(18A):43-43. 被引量:7
  • 5帕坦卡SV.传热与流体流动的数值计算[M].北京:科学出版社,1984..
  • 6卡里尔EE 陈熙 周晓青 译.燃烧室与工业炉的模拟[M].北京:科学出版社,1987..
  • 7萧泽强 吉川邦夫.高温空气燃烧新技术讲座[M].北京:中国科学技术协会工程学会联合会,1999..
  • 8OU Jian-ping, Hsiao Techiang. Investigation and Application of HTAC in China [A]. Kunio Yoshikawa eds, CREST:Fifth International Symposium on High Temperature Air Combustion and Gasification [C]. Yokohama, Tokyo Institute of Technology, 2002. A201-A214.
  • 9Khalil E E, Spalding D B, Whitelaw J H. The calculation of local flow properties in two-dimensional furnaces [J].J Heat Mass Transfer, 1975,18: 775 - 791.
  • 10Jamaluddin A S, Smith P J. Predicting radiative transfer in rectangular enclostures using the discrete ordinates method [J]. Combustion Science and Technology, 1988,59: 321 - 340.

共引文献42

同被引文献17

  • 1欧俭平,詹树华,萧泽强.蓄热式钢包烘烤的数值模拟[J].钢铁研究学报,2005,17(1):19-22. 被引量:13
  • 2秦文,李修海,夏俊华.对蓄热式钢包烘烤器设计的几点看法[J].冶金能源,2006,25(3):27-29. 被引量:4
  • 3Fiveland W A. Discrete Ordinate Solutions of the Radiative Heat Transport Equation for Rectangular Enclosures [J]. J Heat Transfer, 1984,106(2) : 699.
  • 4Turelove J S. Discrete Ordinate Solutions of the Radinate Heat Transport Equation [J]. J Heat Transfer,1987,109(4) :1048.
  • 5Fiveland W A. Discrete ordinate solutions of the radiative heat transport equation for rectangular enclosures [J]. Journal of Heat Transfer, 1984,106 (2) : 699-706.
  • 6Turelove J S. Discrete ordinate solutions of the radinate heat transport equation[J]. Journal of Heat Transfer. 1987, 109(4) : 1048 -1051.
  • 7AEA Technology Engineering Software Ltd. CFX4. 4 Serv- er Manual[M]. Harwell, 1997.
  • 8Weber R, Lverlaan A, Orsino S, et al. On emerging furnace design metbodolgy that provides substantial energy savigns and drastic reductions in CO2, CO and NOx emissions[J]. Institute of Energy, 1999 : 77-83.
  • 9Fiveland W A. Discrete - ordinate Solutions of the Ra-diation -transport Equation for Rectangular Enclosures[J]. Heat Transfer, 1984, 106 (2) ; 699 -706.
  • 10Turelove J S. Discrete - ordinate Solutions of the Radia-tion -transport Equation [ J ]. Heat Transfer, 1987 ,109 (4) : 1048 -1051.

引证文献3

二级引证文献13

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部