期刊文献+

核动力系统冗余泵组的可靠性研究 被引量:5

Study on Reliability of Redundant Standby Pumps in Nuclear-Powered Systems
下载PDF
导出
摘要 根据核动力系统中设备冷却泵的工作状态,将冗余泵组的中止回阀看成两个冗余阀,得出简化的可靠性分析框图,并建立泵组的可靠性分析模型。以核动力装置设备冷却泵组为例,分别计算泵组在3种情况下的可靠度。计算结果表明,冗余泵组比单个泵工作的可靠性高,但冗余泵组中泵和阀之间的相关失效削弱了泵组的可靠性。 According to the work conditions of the component cooling pumps in nuclear-powered systems, the check valve in redundant pumps is taken as two redundant valves. Reliability chart was drawn and reliability analysis model was built up. Based on the example of equipment cooling pumps in nuclear-powered systems, the reliability of pumps in three conditions was separately calculated. Final results show that the reliability of two-component redundancy is much higher than that of single component, but the dependent failures between pumps and valves in redundancy decrease the reliability.
出处 《核动力工程》 EI CAS CSCD 北大核心 2009年第1期5-7,共3页 Nuclear Power Engineering
关键词 冗余泵组 设备冷却水泵 可靠度 相关失效 Redundant pump group, Equipment cooling pumps, Reliability, Dependent failure
  • 相关文献

参考文献3

  • 1Hiromitsu K, Ernest J H. Probabilistic Risk Assessment and Management for Engineers and Scientists[M]. New York, The Institute of Electrical and Electronics Engineers, 1996.
  • 2Ralph R F, Robert E H. Probabilistic Risk Assessment in the Nuclear Power Industry[M]. New York, Brookhaven National Laboratory, 1987.
  • 3赵新文.舰艇核动力-回路装置[M].北京:海潮出版社,2001.

共引文献3

同被引文献33

引证文献5

二级引证文献12

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部