期刊文献+

采用烟气分析法对转炉吹炼过程临界碳含量的研究 被引量:5

Critical carbon content in BOF blowing process with gas analysis
原文传递
导出
摘要 采用烟气分析方法连续获得转炉炉内脱碳反应信息,通过倒推计算法研究了转炉吹炼过程中钢水脱碳速度转折点的临界碳含量.结果表明:熔池搅拌能对反应后期脱碳速度转变的临界碳含量影响比较大,随着底吹供气强度增加,搅拌强度增强,临界碳含量[C]d降低,当熔池搅拌能大于一定值时熔池搅拌能变化对临界碳含量[C]d影响不大.对于顶吹转炉,供氧强度对临界碳含量[C]d影响很大,随着供氧强度提高,临界碳含量[C]d显著降低. Based on the information of decarbonization reaction in a convertor continuously obtained with gas analysis technology, the critical carbon content at the decarbonization rate change point, [ C]d, in BOF blowing process was researched by back-calculation method. The results show that the effect of bath stirring energy on the critical carbon content [C]d is very obvious near the refining end point, and the critical carbon content [C]d decreases with increasing stirring energy due to the increase in bottom blowing flowrate; but when the stirring energy is greater than a certain value, the influence of bath stirring energy on the critical carbon content [C]d is very small. Top oxygen blowing flowrate has important effect on the critical carbon content [C]d for a top blowing converter, and with the increase of oxygen blowing flowrate the critical carbon content [C]d decreases.
出处 《北京科技大学学报》 EI CAS CSCD 北大核心 2009年第2期156-162,共7页 Journal of University of Science and Technology Beijing
关键词 转炉 烟气分析 脱碳 熔池 搅拌能 BOF gas analysis decarbonization bath stirring energy
  • 相关文献

参考文献11

二级参考文献5

  • 1Hei-ichiro.Dynamic Refining Control by Analysis of Exhaust Gas From LD Converter[J].Transactions ISIJ,1987,27(5):351-359.
  • 2Takeshi Takawa.Analysis of Converter Process VariablesFrom Exhaust Gas[J].Transactions ISIJ,1988,28(1):59-67.
  • 3Alok Choudhury.Computerized Control of VOD Process With Application of a Mass Spectrometer[J].Metallurgical Plant and Technology,1988,5:44-52.
  • 4别所永康.排ガス分析情報による底吹き転炉の脱炭反応速度の推定とその吹錬終点制御,ガス回収技術ヘの適用[J].鉄と鋼,1989,(4):610-617.
  • 5胡志刚,刘浏,何平.炉气分析在转炉动态控制中的应用[J].钢铁研究学报,2002,14(3):68-72. 被引量:35

共引文献27

同被引文献30

引证文献5

二级引证文献16

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部