期刊文献+

Ti含量对高强IF钢再结晶温度和力学性能的影响 被引量:9

EFFECT OF Ti CONTENT ON RECRYSTALLIZATION TEMPERATURE AND MECHANICAL PROPERTIES OF HIGH STRENGTH IF STEEL
下载PDF
导出
摘要 对三种不同含钛量的IF钢试验用锭进行了热轧、冷轧和退火试验;采用盐浴退火方法测定了冷轧后试样的再结晶温度;分析了热轧后试样的析出物,测定了退火后试样的力学性能。试验结果表明,Ti含量高于理想化学配比时,与低于理想化学配比时相比,再结晶温度明显提高;在三个试样中,最接近理想化学配比的试样的屈服强度σs和抗拉强度σb最低,而延伸率δ和轧向塑性应变比r0值最高。在Ti含量最高的试样中,可见细小的Fe(TiNb)P析出物。 The test ingots of three different titanium contents were hot rolled, then cold rolled and annealed experimentally. The recrystallization temperatures of cold rolled sample were measured through salt bath annealing. The precipitates of hot rolled sample were analyzed. The mechanical properties of annealed sample were measured. The results showed that the recrystallization temperature was increased significantly when the titanium content was higher than the ideal ratio of components in comparison with that of low ratio of components. The sample, of which titanium content near the ideal chemical ratio, showed the lowest yield strength σa and tensile strength σb, but the highest elongation δand rolling direction plastic strain ration τ0 . The tiny Fe (TiNb)P precipitate could be seen in the sample with the highest titanium content.
出处 《上海金属》 CAS 2009年第3期1-5,共5页 Shanghai Metals
关键词 高强IF钢 TI含量 再结晶温度 力学性能 析出物 High Strength IF Steel, Ti Content, Recrystallization Temperature, MechanicalProperty, Precipitate
  • 相关文献

参考文献7

二级参考文献21

共引文献94

同被引文献74

引证文献9

二级引证文献23

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部