期刊文献+

残余元素铜在中碳钢中的析出规律 被引量:1

Copper Precipitation Behavior in Medium Carbon Steel
原文传递
导出
摘要 以中碳钢为研究对象,调整Mn、S含量,添加0.3%左右的铜作为残余元素,研究铜在钢中的偏析以及在夹杂物上的析出情况。利用扫描电镜及能谱仪研究发现当钢中锰含量从0.0084%提高到0.094%,可以减轻铜沿原奥氏体晶界的偏析程度。锰含量为0.44%时,铜在硫化锰夹杂上的析出比例可以达到94.6%,继续提高锰含量对提高铜的析出比例无益。通过二元匹配度的计算,可以得出,无论Cu在钢中以何种形式存在,MnS夹杂较氧化硅、氧化铝夹杂更适合铜析出,计算结果与实验结果吻合。 In addition of about 0. 30% copper to medium carbon steel, the present study changed the content of manganese and sulfur content to investigate on the effect of manganese and sulfur content on copper precipitation in inclusion, and copper intergranular segregation on the grain boundary during cooling. Manganese content changed from 0. 0084% to 0. 094% , the segregation of copper on the boundary is reduced. When manganese content is 0. 44% , the proportion of copper precipitation in sulfide to the total sulfide is 94. 6%. The manganese content of increasing again is not helpful for increasing the proportion of copper precipitation. The disregistry between the lattice parameters of the copper particles and the inclusions is calculated, which proves manganese sulfide is better to the silicon oxide and aluminum oxide for copper to precipitation on.
出处 《世界科技研究与发展》 CSCD 2009年第4期581-582,580,共3页 World Sci-Tech R&D
基金 国家自然科学基金资助项目(50574009)
关键词 偏析 铜析出 二元匹配度 中碳钢 硫化锰夹杂 segregation copper precipitation disregistry medium carbon steel copper manganese sulfide inclusion
  • 相关文献

参考文献10

  • 1Melford D A. Surface hot shortness in mild steel [ J ]. Journal of Iron and Steel Institute, 1962,200:290 - 299.
  • 2Garza L G,Van Tyne C J. Surface hot-shortness of 1045 forging steel with residual copper[ J]. Journal of Materials Processing Technology, 2005,159:169 - 180.
  • 3Burstrom E. Refining of impurities from steel using ladle metallurgical methods[J]. Scand J Metall,1991,18(2) :126 -133.
  • 4Cramb A W, Fruehan R J. A new low temperature process for copper removal from ferrous scrap[ J]. Iron & Steelmaker, 1991,18 ( 11 ) :61 -68.
  • 5Wang C, Nagasaka T, Hino M, et al. Copper distribution between molten FeS-Na2 S flux and carbon saturated iron melt [ J ]. ISIJ International, 1991,31 ( 11 ) : 1300 - 1308.
  • 6Ono K, Ichise E, Suzuki R O, et al. Elimination of copper from the molten steel by NH3 blowing under reduced pressure [ J ]. Steel Research, 1995,66 (9) : 372 - 376.
  • 7Zaitsev A I,Zaitseva N E, Shakhpazov E K, et al. Evaporation of copper from iron melts [ J ]. ISIJ International,2004,44 (4) :639 - 646.
  • 8Hasegawa H,Nakajima K, Mizoguchi S. Effect of MnS on the heterogeneous nucleation of Cu precipitates in Fe-10 and -5mass% Cu alloys [ J ]. ISIJ International,2003,43 ( 7 ) : 1021 - 1029.
  • 9Liu Z Z, Kobayashi Y, Nagai K, et al. Morphology contral of copper sulfide in strip casting of low carbon steel [ J ]. ISIJ International, 2006,46(5) :744 -753.
  • 10Yamamoto K I, Shibata H, Mizoguchi S. Precipitation behavior of copper, tin and manganese sulfide at high temperature in Fe - 10% Cu - 0.5 % Sn alloys [ J ]. ISIJ International,2006,46 ( 1 ) : 82 - 88.

同被引文献8

引证文献1

二级引证文献8

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部