期刊文献+

采用灭菌器过程记录数据验证灭菌行程各参数值 被引量:1

Recorder Data from Sterilizer to Verify the Sterilization Program Parameters
原文传递
导出
摘要 目的分析医用灭菌器记录仪图纸记录的数据,判断灭菌循环在各行程所用时间与参数值的关系。方法抽选2008年1、5月份两台灭菌器过程记录图纸,以每锅次灭菌循环记录从按启动时内室温度(T1)、夹层温度(T2)、内室压力(P)的动态变化数据,判定真空行程、穿透行程、灭菌行程、回常压及干燥行程所耗时段,计算各时段均值,设样本>2均值时或大于厂家使用说明书参数值1时为不合格数,验证实际灭菌行程耗时与参数值的差异。结果两台灭菌器在按启动开关时内室压力、夹层温度和灭菌行程结束时回常压时间、干燥时间与参数值一致;但在按启动开关时内室温度南44.47℃、中35.28℃,各程序在真空行程、穿透行程、灭菌行程均有时间延长而致总行程时间延长现象(真空行程、穿透行程以本次均值为准,灭菌行程与程序设定参数值为准)。结论真空时间、穿透时间、灭菌时间延长、灭菌循环总时间延长。 OBJECTIVE To analyze the recorder data from medical sterilizer to determine the time of sterilization cycle process and other parameters. METHODS Two sterilizer process records were samplel in Jan and May, 2008, by each pot antiseptic loop record from presses to determine the thalamium temperature (T1), the band temperature (T2), the thalamium pressure (P) the dynamic change data, the determination vacuum traveling schedule, the penetration traveling schedule, the antiseptic traveling schedule, returns to the atmospheric pressure and the dry traveling schedule consumes the time interval, calculates various time intervals average value, supposes the sample to be bigger than when 2 average values or is bigger than factory instruction for use parameter value 1:00 for the unqualified number, the confirmation actual antiseptic traveling schedule time-consuming and the parameter value difference. RESULTS Two in the sterilizer by the start switch when the pressure inside the chamber, the sterilization temperature and mezzanine trip back to the atmospheric pressure at the end of time, drying time with the same parameters; but by the start switch when the room temperature inside the South 44.47℃, in 35.28℃, The procedure in a vacuum trip through tour itinerary sterilization are due to the total travel time is longer (vacuum trip through the average trip to prevail, the sterilization program to set parameters and procedures which). CONCLUSIONS Prolonging the vacuum time, penetration time and sterilization time, the total sterilization cycle time would be protracted.
出处 《中华医院感染学杂志》 CAS CSCD 北大核心 2009年第19期2573-2575,共3页 Chinese Journal of Nosocomiology
关键词 记录仪数据 验证 灭菌循环各行程 参数值 Recorder data Verification Sterilization cycle process Parameters
  • 相关文献

参考文献5

二级参考文献20

  • 1魏静蓉,李彬.化学指示卡灭菌效果监测分析[J].中华医院感染学杂志,2004,14(3):297-298. 被引量:27
  • 2许乐,张晓春.脉动真空压力蒸汽灭菌湿包原因分析与对策[J].中华医院感染学杂志,2005,15(5):536-538. 被引量:46
  • 3王素珍,杨自更,罗兴迪,张道成,雷权.不同海拔高度对压力蒸汽灭菌效果的分析[J].中华医院感染学杂志,2005,15(6):651-653. 被引量:3
  • 4于丽敏 郭阳 等.高压蒸汽灭菌方法的研究[J].中国微生态学杂志,2000,12(1):52-52.
  • 5李英 李青 等.脉动真空灭菌器操作方法的改进[J].中华医院感染学杂志,1999,9(2):73-73.
  • 6孙瑞荣.脉动真空压力蒸汽灭菌器[J].消毒与灭菌,1988,14(5):238-238.
  • 7Anon. Sterilization of medical devices-validation and routine control of sterilization by moist heat:ENSS4[S]. European Committee for Standardization, 1994.
  • 8国家食品药品监督管理局.药品生产验证指南[S].北京:化学工业出版社,2003.5.
  • 9Anon.. Health Teehnieal Memorandum (HTM) 2010-sterilization validation and verification[M]. NHS Estates, An Executive Agency of the British Department of Health, 1998.
  • 10《中华人民共和国国家标准》GB/T20367-2006/ISO13683:1997.

共引文献85

同被引文献6

引证文献1

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部