期刊文献+

合肥光源钮扣型束流位置检测器的设计计算 被引量:3

Design of Button Beam Position Monitor for Hefei Light Source
下载PDF
导出
摘要 对合肥光源中使用的钮扣型束流位置检测器进行了相关参数的计算,计算了水平和垂直方向的灵敏度。对内在分辨率和传输功率进行了估算。用优化后的检测器安装位置参数对束流位置进行了高精度数值仿真,对测量数据用差比和和对数比方法进行处理,得到直观的mapping图和拟合多项式。对束流和信号进行仿真拟合,当束流位移从(0mm,0mm)到(4mm,4mm)时,归一化和信号的变化小于5×10-3。 The calculation of relevant parameters of the button beam position monitor (BPM) at Hefei Light Source (HLS) was presented. The horizontal and vertical sensitivity were calculated. The intrinsic resolution and transmission power were calculated under certain parameters. The high precision beam position was simulated with the optimized detector installation location parameters. The measured data were processed by the difference/sum and log-ratio method to obtain the intuitive mapping figure and fitting polynomial. The sum signal was simulated and fitted. The variety range of normalized sum signal was less then 5×10—3 when the beam displacement changed from (0 mm, 0 mm) to (4 mm, 4 mm).
出处 《原子能科学技术》 EI CAS CSCD 北大核心 2010年第B09期517-521,共5页 Atomic Energy Science and Technology
基金 国家自然科学基金资助项目(10675118 10875117)
关键词 钮扣型 束流位置检测器 灵敏度 mapping图 button beam positionmonitor sensitivity mapping figure
  • 相关文献

参考文献5

  • 1OLMOS A,G(U)NZEL T,P(E)REZ F,et al.BPM design for the ALBA synchrotron[C]//Proceedings of EPAC.Edinburgh,Scotland:[s.n.],2006:1190-1192.
  • 2KUBE G,WERNER M.Signal level calculation for the PETRA III beam position monitor system[C]//Proceedings of DIPAC.Venice,Italy:[s.n.],2007:105-107.
  • 3OLMOS A,PEREZ F.Matlab code for BPM button geometry computation[C]//Proceedings of DIPAC.Venice,Italy:[s.n.],2007:186-188.
  • 4MARCELLINI F,SERIO M,STELLA A,et al.DAQNE broad-band button electrodes[J].Nuclear Instruments and Methods in Physics Research A,1998,402:27-35.
  • 5张佰春,冷用斌.束流位置探头用于束团电荷量测量的数值仿真研究[J].核技术,2009,32(4):256-259. 被引量:4

二级参考文献2

  • 1袁任贤.束流位置测量的研究及其在BEPCⅡ中的应用.博士论文
  • 2Shafer R E. Beam Position Monitoring. Los Alamos National Laboratory

共引文献3

同被引文献22

  • 1岳军会,袁任贤,马力,曹建社.BEPCⅡ横向束流反馈系统条带电极的设计及模拟计算[J].强激光与粒子束,2004,16(10):1353-1355. 被引量:3
  • 2李吉浩,孙葆根,何多慧,刘功发,卢平,曹涌.合肥光源直线加速器BPM系统的研制和测量[J].高能物理与核物理,2007,31(1):96-100. 被引量:4
  • 3李吉浩,孙葆根,何多慧,卢平,王筠华,李鹏.HLS直线加速器条带束流位置检测器基于对数比方法的标定[J].原子能科学技术,2007,41(3):339-342. 被引量:5
  • 4Wu Fangfang,Zhou Zeran,Sun Baogen,et al.Design and simulation of the stripline transverse quadrupole kicker for HLS Ⅱ[C]//Proceedings of IPAC2012.2012:2852-2854.
  • 5Sakanaka S,Kobayashi Y,Mitsuhashi T,et al.Excitation and detection of a transverse quadrupole-mode bunch oscillation in the KEK photon factory storagering[J].Jpn J Appl Phys,2003,42(4):1757-1762.
  • 6Sakanaka S,Mitsuhashi T,Obina T,et al.Measurement of the transverse quadrupole-mode frequencies of an electron bunch in the KEK photon factory storage ring[C]//Proceedings of PAC2003.2003:3207-3209.
  • 7Deibele C,Kurennoy S.Matching BPM stripline electrodes to cables and electronics[C]//Proceedings of PAC2005.2005:2607-2609.
  • 8Olmos A,Pérez F,Rehm G.Matlab code for BPM button geometry computation[C]//Proceedings of DIPAC2007.2007:186-188.
  • 9Olmos A,Günzel T,Pérez F,et al.BPM design for the ALBA Synchrotron[C]//Proceedings of EPAC2006.2006:1190-1192.
  • 10Russell J S,Gilpatrick D J,Power J F,et al.Characterization of beam position monitors for measurement of second moment[C]//Proceedings of PAC1995.1995:2577-2579.

引证文献3

二级引证文献4

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部