期刊文献+

连续管管-管对接打底焊试验研究 被引量:3

An experimental study of the tubing-tubing butt backing weld of coiled tubing
下载PDF
导出
摘要 打底焊对连续管管-管对接焊缝的内成型起着决定性作用,打底焊质量是整个焊缝成型及性能优劣的基础。对直径25.4~50.8mm,壁厚在2.11~4.44mlTl的连续管在其他参数不变的条件下,通过单参数变化,进行了焊接电流、坡口形式及壁厚尺寸对焊缝成型质量的影响规律进行试验研究。结果表明,当壁厚小于3.5mm时,采用V形坡口焊接,可获得平整的内成型;对于壁厚大于3.5mm的连续管打底焊时,采用V形坡口很难获得平整的内成型,需采用U形坡口。 Butt backing weld plays a crucial role in the internal formation of the tubing-tubing butt weld seam of coiled tubing,and the quality of butt welding is the basis for the formation of the whole weld seam and its performance.An experimental study was conducted of the law of the effect of welding current,groove type and the dimensions of wall thickness on the forming quality of the seam in the coiled tubing with a diameter of 25.4~50.8 mm and a wall thickness of 2.11~4.44 mm by means of single-parameter change with all other parameters remaining unchanged.The result indicated that,when the wall thickness was less than 3.5 mm and single V groove welding was adopted,a smooth internal formation could be achieved.When backing welding was done in the coiled tubing with a wall thickness larger than 3.5 mm,it was very difficult to adopt a single V groove to achieve a smooth internal formation.A single U groove should be adopted.
出处 《石油机械》 北大核心 2011年第2期1-3,91,共3页 China Petroleum Machinery
基金 中国石油天然气集团公司"十一五"后三年重大科技基金资助项目"连续管技术与装备研制"(2008C-2004)
关键词 连续管 打底焊 管-管对接 坡口形式 coiled tubing,backing weld,tubing-tubing butt,groove pattern
  • 相关文献

参考文献3

二级参考文献2

  • 1张康达 洪起超.压力容器手册(下)[J].劳动人事,1989,1.
  • 2《技能教材鉴定教材》编审委员会.电焊工(初、中、高)[M].中国劳动出版社,1996,11..

共引文献14

同被引文献24

引证文献3

二级引证文献2

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部