期刊文献+

汽油机起动工况附壁油膜挥发过程的计算分析 被引量:9

Study on Wall-Film Evaporation of Gasoline Engine During Start
下载PDF
导出
摘要 建立了附壁油膜计算模型,研究了进气道喷射摩托车汽油机燃油落点位置、燃油喷射距离及燃油喷射量等参数对起动工况循环内附壁油膜挥发量的影响.分布在进气阀背面上部与进气道交界处附壁油膜挥发速度较大,如果喷射距离过长,部分燃油会分布到温度较低的进气道壁面,导致附壁油膜挥发速度降低.燃油循环喷射量存在一限值:喷射量低于该限值时,循环内附壁油膜挥发量随喷射量的增加而增加;高于该限值时,附壁油膜挥发量随喷射量的增加而减少. The effects of fuel impingement point,spray penetration and fuel injection quantity on wall-film evaporation are studied by numerical simulation based on model validation.The results show that injecting fuel on the juncture of upper area of intake port and intake-valve will improve the evaporation of wall-film.The fuel which drops on cold area will slow down the process of wall-film evaporation.The fuel injected in a cycle should be less than a limit,otherwise the evaporation of wall-film will decrease with the increase of fuel injection.
出处 《燃烧科学与技术》 EI CAS CSCD 北大核心 2010年第6期503-507,共5页 Journal of Combustion Science and Technology
基金 教育部留学回国人员科研启动基金资助项目 天津大学内燃机燃烧学国家重点实验室开放基金资助项目(SKLE200908)
关键词 汽油机 进气道喷射 附壁油膜挥发 gasoline engine port fuel injection(PFI) wall-film evaporation
  • 相关文献

参考文献10

  • 1张翠平,杨庆佛.电控汽油机燃油喷射匹配的试验研究[J].农业机械学报,2004,35(2):25-28. 被引量:6
  • 2赵弘志,曹林.CA6102电控汽油机废气再循环性能研究[J].汽车工程,2005,27(2):264-268. 被引量:6
  • 3Shankar R,Udayakumar G,Sasikumar K.Advanced port injection solution for motorcycle application[C]//SAE Paper.Detroit,MI,USA,2008,2008-28-0031.
  • 4Cho H,Min K.Measurement of liquid fuel film distri-bution on the cylinderliner of a spark ignition engine US-ing the laser induced fluorescence technique[J].Meas-urement Science and Technology,2003,14(7):975-982.
  • 5Almkvist G,Denbratt I,Josefsson G,ct al.Measure-ments of fuel film thickness in the inlet port of an SI en-gine by laser induced fluorescence[C]//SAE Paper.De-troit,MI,USA,1995,952483.
  • 6Johnen T,Haug M.Spray formation observation and fuel film development measurements in the intake of a spark ignition engine[C]// SAE Paper.Detroit,MI,USA,1995,950511.
  • 7杨延平,陆振华.汽油机冷起动附壁油膜研究[J].内燃机工程,2008,29(5):47-51. 被引量:6
  • 8程用胜,陆振华,邓康耀,杨延平.空气流速对附壁油膜分布影响的试验研究[J].内燃机学报,2008,26(5):429-433. 被引量:4
  • 9Gregor Rottenkolber,Klaus Dullenkopf,Sigmar Wiaig,ct al.Influence of mixture preparation on com-bustion and emissions inside an SI engine by mewls of visualization,PIV and IR thermograph during cold op-crating conditions[C]//SAE Paper.Detroit,MI,USA,1999,1999-01-3644.
  • 10YahWM,LinT F.Combinedheat and mass transfer in natural convection between vertical parallel plates with film evaporation[J].Int JHeat Mass Transfer,1990,33(3):529-541.

二级参考文献22

  • 1何旭,刘卫国,高希彦,廖春明,杨德胜,赵大文.直喷式柴油机燃油撞壁特性及混合气形成研究[J].内燃机工程,2006,27(2):11-14. 被引量:5
  • 2黄英,张付军,孙业保,赵长禄,刘福水.JL462Q汽油机集中控制系统的研究[J].内燃机学报,1997,15(1):51-61. 被引量:1
  • 3于健.465QA电控汽油喷射汽油机的研究与试验[A]..1999年山西省汽车工程学会优秀论文集[C].,1999.51-57.
  • 4Senda J, Ohnishi M, Takahashi T, et al. Measurement and Modeling on Wall Wetted Fuel Film Profile and Mixture Preparation in Intake Port of SI Engine [ C ]. SAE Paper 1999-01-0798, 1999.
  • 5Almkvist G, Denbratt I, Josefsson G, et al. Measurements of Fuel Film Thickness in the Inlet Port of an SI Engine by Laser Induced Fluorescence[ C ]. SAE Paper 952483,1995.
  • 6Johnen T, Haug M. Spray Formation Observation and Fuel Film Development Measurements in the Intake of a Spark Ignition Engine [C]. SAE Paper 950511, 1995.
  • 7Steinbrenner J E, Hidrovo C H, Wang F M, et al. Measurement and Modeling of Liquid Film Thickness Evolution in Stratified Two-Phase Microchannel Flows [ J ]. Applied Thermal Engineering, 2007, 27(10) : 1722-1727.
  • 8Moon S, Bae C, Choi J, et al. The Influence of Airflow on Fuel Spray Characteristics from a Slit Injector [ J]. Fuel, 2007, 86 (3) : 400-409.
  • 9Stanton D W, Rutland C J. Modeling Fuel Film Formation and Wall Interaction in Diesel Engines [ C ]. SAE Paper 960628, 1996.
  • 10Stanton D W, Rutland C J. Multi-Dimensional Modeling of Thin Liquid Films and Spray-Wall Interactions Resulting from Impinging Sprays [ J J. International Journal of Heat and Mass Transfer, 1998, 41 (20) : 3037-3054.

共引文献15

同被引文献66

引证文献9

二级引证文献31

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部