期刊文献+

Microstructure and micro-hardness of the Inconel 718 superalloy coating prepared by cold gas dynamic spraying

Microstructure and micro-hardness of the Inconel 718 superalloy coating prepared by cold gas dynamic spraying
下载PDF
导出
摘要 Inconel 718 superalloy coating was prepared on a martensitic steel substrate by cold gas dynamic spraying ( CGDS ). Microstructure and micro-hardness of the coating were characterized by means of scanning electronic microscope (SEM) ,energy dispersive spectrometer (EDS), and micro-hardness and nano-indentation tests. The results have indicated that the coating' s thickness can reach more than 300 um, and there exists a good interfacial cohesion between the coating and the substrate. The quantity and size of the defects at the bottom, middle and top areas increase gradually. There is no significant change to the original microstructure of the Inconel 718 superalloy particle after the process of CGDS ;and an obvious torsional deformation on the particle' s profile is produced while little deformation at the center part occurs. The micro-hardness of the coating at the bottom, middle and top areas decreases in turn. Compared with the bottom area, the micro-hardness of the middle and top areas decreases by about 10% and 21%, respectively. The nano-hardness of the coating is much lower than the original particle,which decreases by about 13.5% at the bottom area and 28% at the top area,respectively. The distribution of micro-defects is an important factor to the micro-hardness of the coating. Inconel 718 superalloy coating was prepared on a martensitic steel substrate by cold gas dynamic spraying ( CGDS ). Microstructure and micro-hardness of the coating were characterized by means of scanning electronic microscope (SEM) ,energy dispersive spectrometer (EDS), and micro-hardness and nano-indentation tests. The results have indicated that the coating' s thickness can reach more than 300 um, and there exists a good interfacial cohesion between the coating and the substrate. The quantity and size of the defects at the bottom, middle and top areas increase gradually. There is no significant change to the original microstructure of the Inconel 718 superalloy particle after the process of CGDS ;and an obvious torsional deformation on the particle' s profile is produced while little deformation at the center part occurs. The micro-hardness of the coating at the bottom, middle and top areas decreases in turn. Compared with the bottom area, the micro-hardness of the middle and top areas decreases by about 10% and 21%, respectively. The nano-hardness of the coating is much lower than the original particle,which decreases by about 13.5% at the bottom area and 28% at the top area,respectively. The distribution of micro-defects is an important factor to the micro-hardness of the coating.
出处 《Baosteel Technical Research》 CAS 2011年第1期41-44,共4页 宝钢技术研究(英文版)
关键词 cold gas dynamic spraying (CGDS) inconel 718 superalloy MICROSTRUCTURE micro-hardness cold gas dynamic spraying (CGDS) inconel 718 superalloy microstructure micro-hardness
  • 相关文献

参考文献12

  • 1娄学明,孙文儒,郭守仁,胡壮麒.IN718高温合金热腐蚀行为及其对力学性能的影响[J].稀有金属材料与工程,2008,37(2):259-263. 被引量:26
  • 2Kuo C M,Yang Y T,Bor H Y,et al. Aging effects on the microstructure and creep behavior of Inconel718 superalloy[J]. Materials Science and Engineering,2009, 510-511:289-294.
  • 3Slama C and Abdellaoui M. Structural characterization of the aged Inconel 718 [J]. Journal of Alloys and Compounds, 2000,306 : 277 -284.
  • 4Leger A C,Wigren J and Hansson M O. Development of a process window for a NiCoCrA1Y plasma-sprayed coating[J]. Surface and Coating Technology, 1998,108-109 z 86-92.
  • 5La Barbera-Sosa J G, Santana Y Y, Staia M H, et al. Microstructural and mechanical characterization of Ni- base thermal spray coatings deposited by HVOF[J]. Surface & Coating Technology ,2008,202:4552-4559.
  • 6Hedges Matthew K, Newbery A P and Grant P S. Characterisation of electric arc spray formed Ni superalloy IN 718[J]. Materials Science and Engineering ,2002, A326:79-91.
  • 7Li Meiheng, Sun Xiaofeng, Hu Wangyu, et al. Micro- structral changes and elemental diffusion of sputtered NiCrA1Y coating on a Ni-base SC superalloy subjected to high temperature [J]. Materials Letters, 2007,61 : 5169- 5172.
  • 8Liu Fencheng, Lin Xin, Yang Gaolin, et al. Micro- structure and residual stress of laser rapid formed Inconel 718 nickel-base superalloy [J]. Optics & Laser Technology ,2011,43:208-213.
  • 9Chen S, Qu S J, Liang J, et al. Sintering and micro- structure evolution of columnar nickel-based superalloy sheets prepared by EB-PVD[J]. Journal of Alloys and Compounds, 2010,507 : 146 - 150.
  • 10Alkimov A P, Kosarev V F and Papyrin A N. A method of cold gas dynamic deposition [J].Dokl Akad Nauk SSSR, 1990,315 (5) : 1062-1065.

二级参考文献50

  • 1李文亚,李长久,王豫跃,杨冠军.冷喷涂Cu粒子参量对其碰撞变形行为的影响[J].金属学报,2005,41(3):282-286. 被引量:57
  • 2Ajdelsztajn L,Jodoin B,Kim G E,et al.Cold spray deposition of nanocrystalline aluminum alloys.Metall Mater Trans A,2005,36(3):657
  • 3Sanghoon Yoon,Changhee Lee,Hansin Choi,et al.Kinetic spraying deposition behavior of bulk amorphous NiTiZrSiSn feedstock.Mater Sci Eng A,2006,415(1-2):45
  • 4Stoltenhoff T,Borchers C,Gartner C,et al.Microstructures and key properties of cold-sprayed and thermally sprayed copper coatings.Surf Coat Techn,2006,200(16-17):4947
  • 5Barradas S,Molins R,Jeandin M,et al.Application of laser shock adhesion testing to the study of the interlamellar strength and coating-substrate adhesion in cold-sprayed copper coating of aluminum.Surf Coat Techn,2005,197(1):18
  • 6Li Changjiu,Li Wenya.Deposition characteristics of titanium coating in cold spraying.Surf Coat Techn,2003,167(2-3):278
  • 7Lima R S,Kucuk A,Berndt C C.Deposition efficiency,mechanical properties and coating roughness in cold-sprayed titanium.J Mater Sci Lett,2002,21(21):1687
  • 8Lima R S,Karthikeyan J,Kay C M,et al.Microstructural characteristics of cold-sprayed nanostructured WC-Co coatings.Thin Solid Films,2002,416(1-2):129
  • 9Hyung-Jun Kim,Chang-Hee Lee,Soon-Young Hwang.Fabrication of WC-Co coatings by cold spray deposition.Surf Coat Techn,2005,191(2-3):335
  • 10Hyung-Jun Kim,Chang-Hee Lee,Soon-Young Hwang.Superhard nano WC-12%Co coating by cold spray deposition.Mater Sci Eng A,2005,391(1-2):243

共引文献38

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部