期刊文献+

Ni-MoS_2梯度复合镀层结合强度研究

Study on adhesion strength of Ni-MoS_2 gradient composite coating
原文传递
导出
摘要 在含有NiSO4·6H2O240g/L、NiCl2·6H2O45g/L、H3BO330g/L、Na2SO420g/L、CTAB0.4mg/L和MoS25g/L的镀液中,通过调整复合电镀参数制备了MoS2梯度复合镀层。研究了不同参数下,所得复合镀层的结合强度。结果表明,复合梯度镀层的结合强度均大于均匀镀层。采用电流密度3A/dm2、搅拌速率350r/min、温度35°C的工艺初镀10min,然后逐渐调整电镀参数到电流密度11A/dm2、搅拌速率600r/min、温度55°C再镀10min,得到的梯度复合镀层的结合强度最大,为41N,是均匀镀层的2倍。 Ni-MoS2 gradient composite coatings were prepared from a bath containing NiSO4·6H2O 240 g/L,NiCl2·6H2O 45 g/L,H3BO3 30 g/L,Na2SO4 20 g/L,CTAB 0.4 mg/L,and MoS2 5 g/L by adjusting the composite plating parameters,and their adhesion strengths were studied.The results indicated that the adhesion strengths of all composite gradient coatings are higher than that of a uniform coating.The gradient composite coating with the highest adhesion strength of 40 N,which is double that of the uniform coating,can be obtained in the following way:the composite plating is conducted initially at temperature 35 °C,current density 3 A/dm^2,and stirring rate 350 r/min for 10 min,and then continued with gradually adjusted parameters,with the final values of temperature 55 °C,current density 11 A/dm^2,and stirring rate 600 r/min for 10 min.
机构地区 安徽工程大学
出处 《电镀与涂饰》 CAS CSCD 北大核心 2011年第4期9-12,共4页 Electroplating & Finishing
基金 安徽工程大学人才引进启动基金(S05035)
关键词 二硫化钼粒子 复合镀 梯度镀层 结合强度 nickel molybdenum disulfide particle composite plating gradient coating adhesion strength
  • 相关文献

参考文献23

  • 1王宏智,张卫国,姚素薇.电沉积梯度功能镀层的研究进展[J].电镀与环保,2001,21(3):1-4. 被引量:14
  • 2文明芬,刘晓冰,张晶,杨继红.功能梯度材料的新型制备法-多层复合镀[J].电镀与涂饰,1999,18(1):44-46. 被引量:12
  • 3LEON C A, DREW R A L. Small punch testing for assessing the tensile strength of gradient AI/Ni-SiC composites [J]. Materials Letters, 2002, 56 (5): 812-816.
  • 4KIM S K, YOO H J. Formation of bilayer Ni-SiC composite coatings by electrodeposition [J]. Surface and Coatings Technology, 1998, 108/109: 564-569.
  • 5ORLOVSKAJA L, PERIENE N, KURTINAITIENE M, et al. Ni-SiC composite plated under a modulated current [J]. Surface and Coatings Technology. 1999. 111 (2/3): 234-239.
  • 6WANG H Z, YAO S W, MATSUMURA S. Electrochemical preparation and characterization of Ni/SiC gradient deposit [J]. Journal of Materials Processing Technology, 2004, 145 (3): 299-302.
  • 7ORLOVSKAJA L, MEDEL1ENE V, KURTINA1T1ENE M, et al. Electrodeposition of multiplayer cobalt silicon carbide composite coatings from a single bath [J]. Bulletin of Electrochemistry, 2001, 17 (8): 371-376.
  • 8胡炜,谭澄宇,崔航,刘宇.Ni-SiC复合梯度镀层的耐腐蚀性能[J].材料保护,2009,42(6):17-19. 被引量:6
  • 9ZHAO Q, LIU Y, MOLLER~STEINHAGEN H, et al. Graded Ni-P-PTFE coatings and their potential applications [J]. Surface and Coatings Technology, 2002, 155 (2/3): 279-284.
  • 10王立平,高燕,刘惠文,徐洮.电沉积梯度Ni-Co纳米合金镀层的研究[J].电镀与涂饰,2004,23(6):5-7. 被引量:14

二级参考文献171

共引文献107

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部