期刊文献+

3.6m大口径镀膜机膜厚均匀性分析 被引量:8

Analysis of Film Thickness Uniformity for Large Aperture Coater of 3.6 m in Diameter
下载PDF
导出
摘要 分别建立了旋转平面与球面夹具配置下的薄膜膜厚均匀性理论计算模型,对3.6m大口径镀膜机下直径为2.6m基板的膜厚均匀性进行了研究。为了改善膜厚均匀性,分别采用两个蒸发源和三个蒸发源进行蒸镀。薄膜的膜厚不均匀性通过理论计算模型进行优化计算得到。对于两个蒸发源,分别得到了两旋转夹具配置下的最优几何配置,对应的膜厚不均匀性最小值分别为7.62%和5.58%。对于三个蒸发源,也分别得到了两旋转夹具配置下的最优几何配置,对应的膜厚不均匀性最小值分别为5.79%和3.48%。结果表明:采用三个蒸发源能更好的改善膜厚分布,而且旋转球面夹具配置下得到的膜厚均匀性整体上较好。 The theoretical calculation models for the rotating flat and spherical fixture configurations have been established respectively and the thickness uniformity of 2.6 m substrates in large aperture coater of 3.6 m in diameter have been studied. In order to improve the thickness uniformity, two sources and three sources have been employed. The thickness nonuniformity was acquired via the optimization calculations using the theory models. The optimal geometric configurations were obtained for two sources with the two rotating fixture configurations respectively, and the corresponding minima of thickness nonuniformity were 7.62% and 5.58%, respectively. For three sources, in the same way, the corresponding minima of thickness nonuniformity were 5.79% and 3.48%, respectively. It is found that compared with two sources, three sources can improve the thickness distribution to a great extent. Moreover, the thickness distribution obtained with the rotating spherical fixture configuration performs well as a whole.
出处 《光电工程》 CAS CSCD 北大核心 2011年第11期73-78,共6页 Opto-Electronic Engineering
关键词 大口径镀膜机 理论计算模型 膜厚分布 均匀性 薄膜 large aperture coater theoretical calculation models thickness distribution uniformity thin film
  • 相关文献

参考文献11

  • 1Jaing C C, Cheng M H, Chen J S, et al. Studying layer uniformity of sputter coatings by intensity distribution of plasma spectrum [J]. Applied Surface Science(S0169-4332), 2001, 169/170: 649-653.
  • 2Wang Feiling, Crocker R, Faber R. Large-area Uniformity in Evaporation Coating through a New Form of Substrate Motion [C]//Manufaeturing Contest and Large Area Coatings, Tucson, AZ, Jlme 6, 2010: 1-3.
  • 3Aimin V, Gubanova L A, Putilin S. Increasing the coating-uniformity zone when insulators are thermally evaporated in vacuum [J]. J.Opt.Technol(S1070-9762), 2006, 73(8): 555-558.
  • 4Arkwright J, Underhill I, Pereira N, et al. Deterministic control of thin film thickness in physical vapor deposition systems using a multi-aperture mask [J]. Optics Express(S 1094-4087), 2005, 13(7): 2731-2741.
  • 5Lee C C, Chuang K P, Wu J Y. Thickness distribution of thin films deposited by ion beam sputtering [C]//Deposition of Optical Coating, Banff, Canada, July l5, 2001: 1-4.
  • 6Macleod H A. Thin-Film optical f'dters, 3rd edition [M].Bristol and Philadelphia: Institute of Physics Publishing, 2001, 488.
  • 7WANG Jian-guo, SHAG Jian-da, YI Kui, et al. Layer uniformity of glancing angle deposition [J].Vaeuum(S0022-5355), 2005, 78: 107-111.
  • 8Kotlikov E N, Prokashev V N, Ivanov V A, et al. Thickness uniformity of films deposited on rotating substrates [J]. J.Opt.Teehnol(S1070-9762), 2009, 76(2): 100-103.
  • 9王长军,熊胜明.大口径光学元件薄膜厚度均匀性修正[J].强激光与粒子束,2007,19(7):1153-1157. 被引量:14
  • 10Oliver J B, Talbot D. Optimization of deposition uniformity for lager-aperture national Ignition Facility substrates in a planetary rotation system [J]. Appl. Opt(S1559-128X), 2006, 45(13): 3097-3105.

二级参考文献9

共引文献31

同被引文献45

引证文献8

二级引证文献19

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部