期刊文献+

Ti_(50)Al_(50)N硬质涂层的热稳定性及力学性能研究

Research on Thermal Stability and Mechanical Properties of Ti_(50)Al_(50)N Coating
下载PDF
导出
摘要 Ti50Al50N涂层是一种新型硬质涂层材料,其热稳定性影响切割刀具的使用寿命和切削效率。文中采用热处理模拟实际工况条件,研究利用多弧离子镀技术制备Ti50Al50N硬质涂层的热稳定性,采用SEM、XRD等方法对涂层的形貌和相组成进行分析,并检测经不同温度处理后的涂层显微硬度。结果表明:Ti50Al50N硬质涂层的硬度随温度升高而提高,在850℃达到最大值,之后随温度继续升高而降低。XRD分析结果表明:随着处理温度升高,Ti50Al50N硬质涂层的相组成发生变化,从中析出AlN相;在更高的温度下,涂层中的Al发生氧化,导致涂层硬度下降。结果说明Ti50Al50N硬质涂层在850℃以下热稳定性较好,利于切削工作. As a new type of hard coating,Ti50Al50N was used in the machining field.Thermal stability of coating plays a key role in the life and cutting efficiency of Ti50Al50N-coated tools.In this paper,the stability of Ti50Al50N coating was investigated through heat treatment that simulated actual working conditions.SEM and XRD were used to study morphologic evolution and phase transformation in the heated coating,and microhardness was measured with tester.The results show that with increasing of temperature,microharness of treated specimen increase and achieve the maximum value at 850 ℃,then decrease.Correspondingly,with increasing of temperature,AlN phase precipitates from coating and at higher temperature oxidation of Al in coating leads to microhardness decrease.It implies that Ti50Al50N coating keeps thermal stability under 850℃,which is conducive to the cutting work.
出处 《沈阳理工大学学报》 CAS 2011年第4期56-58,共3页 Journal of Shenyang Ligong University
关键词 Ti50Al50N 热稳定性 热处理 显微硬度 Ti50Al50N thermal stability heat treatment microhardness
  • 相关文献

参考文献6

二级参考文献44

  • 1李建平,高见,曾祥才,马文存.中温化学气相沉积(MTCVD)工艺技术及超级涂层材料的研究[J].工具技术,2004,38(9):72-75. 被引量:14
  • 2孙荣幸,张同俊,戴伟,李松.TiB_2和Ti-B-N涂层的性能对比研究[J].材料工程,2006,34(4):41-43. 被引量:3
  • 3畅庚榕,郭岩,马胜利,徐可为.脉冲直流PCVD制备新型Ti-Si-C-N纳米复合超硬薄膜[J].稀有金属材料与工程,2006,35(5):824-827. 被引量:5
  • 4J Perez-Mariano,K H lau,A Sanjurjo,et al.TiSiN nanocomposite coatings by chemical vapor deposition in a fluidized bed reactor at atmospheric pressure(APFBR-CVD)[J].Sudace Coatings and Technology,2006(201):2217-2225.
  • 5N Jiang,Y G Sben,H J Zhng,et al.Superhared nanocomposite Ti-Al-Si-N films deposited by reactive unbalanced magnetron stuttering[J].Materials Science and Engineering B,2006(135):1-9.
  • 6C S Chen,C P Liu,C Y Tsao,et al.Study of mechanical properties of PVD ZrN films de-posited under pasitive and negative substrate bias conditions[J].Scripta Materialia,2004(5):715-719.
  • 7Y L Su,S H Yao,Z l Leu,et al.Comparison of tribological behavior of three films TiN,TiCN and CrN grown by physical vapot depo-sition[J].Wear,1997(213):165-174.
  • 8J Perez-Mariano, K H lau, A Sanjurjo, et al. TiSiN nanocomposite coatings by chemical vapor deposition in a fluidized bed reactor at atmospheric pressure (APFBR - CVD) [J]. Surface Coatings and Technology, 2006,201 : 2217 - 2225.
  • 9N Jiang, Y G Shen, H J Zhang, et al. Superhard nanocomposite Ti- Al- Si - N films deposited by reactive unbalanced magnetron sputtering [ J]. Materials Science and Engineering B, 2006,135 : 1-9.
  • 10C S Chen, C P Liu, C Y Tsao, et al. Study of mechanical properties of PVD ZrN films deposited under positive and negative substrate bias conditions[J]. Scripta Materialia,2004(5):715- 719.

共引文献45

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部