摘要
引言汽油中的硫化物燃烧生成的SOx是汽车尾气中的主要污染物之一,世界各国为此严格限制燃料油中硫含量,欧美等国家对汽、柴油的硫含量分别限制在30μg.g-1以下和50μg.g-1左右,国内汽油硫含量标准控制在150μg.g-1[1]。目前,脱硫技术主要有加氢脱硫和非加氢脱硫。加氢脱硫（HDS）[2]是从各种馏出物中脱除硫的有效技术,
One of main pollutants in air is sulfur oxides that comes from the combustion of coal and transportation fuels.There are some regulations or rules in many countries,which set the level of sulfur content in transportation fuels,so it becomes urgent to do ultra-deep desulfurization.Hydro-desulfurization process is usually used in petroleum refining industry,in which compounds containing-sulfur are converted to H2S removed in high temperature and high hydrogen pressure.However it is difficult for removing aromatic heterocyclic sulfur.So,alterative technologies have been developed,such as adsorptive-,oxidative-and bio-desulfurization.In this paper a desulfurization agent for residue fluid catalytic cracking gasoline（RFCCG） was prepared by impregnation technique.The compounds of transition metals（Fe,Cu） were used as active component and the attapulgite,treated with nitric acid,as carrier.The sulfur content in RFCCG was analyzed by gas chromatography with atomic emission detection（GC-AED）.The desulfurization agent was characterized by fourier transform infrared spectrometer（FTIR）,X-ray diffraction（XRD）,BET and X-ray photoelectron spectroscopy（XPS）.The parameters of desulfurization process for the agent were optimized by experimental study designed by the orthogonal test.The results indicated that the best desulfurization agent obtained are 7% Fe and 6% Cu compounds on attapulgite which was acidulated and roasted at 450℃ for 5 h.The desulfurization rate was 70.02% at atmosphere pressure and room temperature,and sulfur content in RFCCG reduced from 804 μg·g-1 to 241 μg·g-1.
出处
《化工学报》
EI
CAS
CSCD
北大核心
2012年第1期292-300,共9页
CIESC Journal
基金
甘肃省攻关基金项目(2GSO47-A52-001-05)
中国科学院知识创新工程重要方向项目(KZCX2-YW-Q05-05)~~
关键词
浸渍法
脱硫剂
凹凸棒黏土
RFCC汽油
硫醇
硫醚
immersion methods
desulfurization desulfurizer
attapulgite clay
RFCC gasoline
thiol
thioether
