期刊文献+

AM80-0.2Sr-1.5Ca镁合金高温压缩过程动态再结晶模拟 被引量:8

Simulation of the Dynamic Recrystallization of AM80-0.2Sr-1.5Ca Magnesium Alloy during Hot Compression Deformation
下载PDF
导出
摘要 在Gleeble-1500热压缩实验机上对AM80-0.2Sr-1.5Ca镁合金进行高温压缩实验,得到了该合金在温度为300~450 ℃、应变速率为0.01~1 s-1条件下的流变应力曲线.结合改进的Laasraoui-Jonas(L-J)位错密度模型和Kock-Mecking(K-M)位错密度模型,获得AM80-0.2Sr-1.5Ca镁合金在改进的L-J位错密度模型中的应变硬化参数和应变软化参数,建立该合金的动态再结晶模型.利用DEFORM-3D软件,实现了对AM80-0.2Sr-1.5Ca镁合金在450 ℃热压缩实验时微观组织演变和位错密度变化过程的有限元模拟,并与实际热压缩实验微观组织进行对比.研究结果表明:在相同的温度和应变量下,应变速率较低时,AM80-0.2Sr-1.5Ca镁合金组织粗大且晶粒分布不均,随着应变速率增大,再结晶组织细小均匀模拟与实验结果一致,说明求解的应变硬化参数和应变软化参数准确,所建立的动态再结晶模型能准确预测该合金高温压缩过程动态再结晶过程. Hot compression tests of a new type of AM80-0.2Sr-1.5Ca magnesium alloy were performed on Gleeble-1 500 at a strain rate of 0.01~1 s-1 and a deformation temperature of 300~450 ℃. The true stress-true strain curves and the strain hardening rate were obtained. The parameters of the modified L-J microstructure model, including the hardening parameter and recovery parameter, were calculated by combining the L-J model with K-M model. The evolution of the microstructure and dislocation density of the AM80-0.2Sr-1.5Ca magnesium alloy during the hot compression at 450 ℃ were simulated by using DEFORM-3D software. The results have shown that the recrystallized grains are larger and distribute non-uniformly when the strain rates are low, and the recrystallized grain size decreases with the increase of strain rate. The simulation results agree well with the experiments, which prove the accuracy of the L-J modeling for predicting the DRX process during hot compression.
出处 《湖南大学学报(自然科学版)》 EI CAS CSCD 北大核心 2011年第12期46-51,共6页 Journal of Hunan University:Natural Sciences
基金 国家自然科学基金资助项目(51075132) 湖南省杰出青年基金资助项目(09JJ1007) 教育部长江学者与创新团队发展计划资助项目(531105050037) 湖南大学汽车车身先进设计制造国家重点实验室自主课题资助项目(61075005)
关键词 L—J微观组织模型 微观组织模拟 动态再结晶 位错密度 L-J microstructure model microstructure simulation dynamic recrystallization dislocation density
  • 相关文献

参考文献18

  • 1AGHION E, BRONFIN B. Magnesium alloys development towards the 21st century[J]. Materials Science Forum, 2000, 350/351 : 19-- 30.
  • 2王文先,张金山,许并社.镁合金材料的应用及其加工成型技术[J].太原理工大学学报,2001,32(6):599-603. 被引量:45
  • 3FRIEDRICH H, .SCHUMANN S. Research for a "new age of magnesium" in the automotive industry[J]. Mater Process Tech, 2002, 117(3) : 276--281.
  • 4梁桂平,白星,李落星,刘波,刘扬胜.AM80-xSr-yCa镁合金高温压缩变形行为[J].塑性工程学报,2010,17(1):98-103. 被引量:5
  • 5CHEN Fei, CUI Zhen shah, IJU Juan,et al. Modeling and simulation on dynamic recrystallization of 30Cr2Ni4MoV rotor steel using the cellular automation method[J].odeling simul Mater Sci Eng, 2009, 17(7):1--19.
  • 6RADHAKRISHNAN B, SARMA G, ZACHARIA T. Monte carlo simulation of deformation substructure evolution during recrystallization[J]. Seripta Metallurgica, 1998, 39(12) : 1639-- 1645.
  • 7WANG S L, SEKERKA R E. Thermodynamically-consistent phasefield models for solidification[J]. Physica D: Nonlinear Phenomena, 1993, 69(1/2) : 189--200.
  • 8QIAN M, C-OU Z X. Cellular automata simulation of microstructural evolution during dynamic recrystllization of an HY-100 steel[J]. Mater Sci Eng A, 2004, 365(1/2):180--185.
  • 9GOETZ R L, SEETHARAMAN V. Modeling dynamic recrystallization using cellular automata[J]. Scripta Mater, 1998, 38(3) : 405-- 413.
  • 10DING R, GUO Z X. Coupled quantitative simulation of microstructrue evlotion and plastic flow during dynamic recrystallization[J]. Aeta Mater ,2001, 49(16) :3163--3175.

二级参考文献21

共引文献48

同被引文献83

  • 1陈淑英,常国威,黄玉多,刘升阳.熔体温度对AZ31B镁合金铸态组织及力学性能的影响(英文)[J].中国有色金属学会会刊:英文版,2013,23(6):1602-1609. 被引量:3
  • 2陈学文,陈天安,周会军,朱美玲.45Cr4NiMoV合金动态再结晶临界应变[J].材料热处理学报,2015,36(1):109-113. 被引量:13
  • 3陈振华,夏伟军,程永奇,傅定发.镁合金织构与各向异性[J].中国有色金属学报,2005,15(1):1-11. 被引量:104
  • 4何燕,张立文,牛静,裴继斌.元胞自动机方法对动态再结晶过程的模拟[J].材料热处理学报,2005,26(4):120-124. 被引量:30
  • 5潘金生,仝健民,田民波,等,材料科学基础[M].北京:清华大学出版社,2007.
  • 6AGHION E, BRONFIN B. Magnesium alloys developmenttowards the 21st century[J]. Materials Science Forum, 2000,350/351: 19-30.
  • 7FRIEDRICH H, SCHUMANN S. Research for a “new age ofmagnesium” in the automotive industry [J], Mater Process Tech,2002, 117(3): 276-281.
  • 8HUMPHREYS F J, HATHERLY M. Recrystallization andrelated annealing phenomena[M]. Oxford: Pergamon, 1995.
  • 9DING R, GUO Z X. Coupled quantitative simulation ofmicrostructure evolution and plastic flow during dynamicrecrystallization[J]. Acta Materialia, 2001, 49: 3163—3175.
  • 10CHEN Fei, CUI Zhen-shan, LIU Juan, ZHANG Xiao-xun,CHEN Wen. Modeling and simulation on dynamicrecrystallization of 30Cr2Ni4MoV rotor steel using the cellularautomaton method[J]. Modeling and Simulation in MaterialsScience and Engineering, 2009, 17: 1-19.

引证文献8

二级引证文献39

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部