摘要
Significant concerns have been raised over the presence of antibiotics including tetracyclines in aquatic environments.A series of FeMn binary oxide with different Fe：Mn molar ratios was synthesized by a simultaneous oxidation and coprecipitation process for TC removal.Results showed that Fe-Mn binary oxide had higher removal efficiency than that of hydrous iron oxide and hydrous manganese oxide,and that the oxide with a Fe：Mn molar ratio of 5：1 was the best in removal than other molar ratios.The tetracycline removal was highly pH dependent.The removal of tetracycline decreased with the increase of initial concentration,but the absolute removal quantity was more at high concentration.The presence of cations and anions such as Ca2＋,Mg2＋,CO32-and SO42-had no significant effect on the tetracycline removal in our experimental conditions,while SiO32-and PO43-had hindered the adsorption of tetracycline.The mechanism investigation found that tetracycline removal was mainly achieved by the replacement of surface hydroxyl groups by the tetracycline species and formation of surface complexes at the water/oxide interface.This primary study suggests that Fe-Mn binary oxide with a proper Fe：Mn molar ratio will be a very promising material for the removal of tetracycline from aqueous solutions.
Significant concerns have been raised over the presence of antibiotics including tetracyclines in aquatic environments.A series of FeMn binary oxide with different Fe：Mn molar ratios was synthesized by a simultaneous oxidation and coprecipitation process for TC removal.Results showed that Fe-Mn binary oxide had higher removal efficiency than that of hydrous iron oxide and hydrous manganese oxide,and that the oxide with a Fe：Mn molar ratio of 5：1 was the best in removal than other molar ratios.The tetracycline removal was highly pH dependent.The removal of tetracycline decreased with the increase of initial concentration,but the absolute removal quantity was more at high concentration.The presence of cations and anions such as Ca2＋,Mg2＋,CO32-and SO42-had no significant effect on the tetracycline removal in our experimental conditions,while SiO32-and PO43-had hindered the adsorption of tetracycline.The mechanism investigation found that tetracycline removal was mainly achieved by the replacement of surface hydroxyl groups by the tetracycline species and formation of surface complexes at the water/oxide interface.This primary study suggests that Fe-Mn binary oxide with a proper Fe：Mn molar ratio will be a very promising material for the removal of tetracycline from aqueous solutions.
基金
supported by the Fund for the Creative Research Groups of China (No. 50921064)
the Special Co-construction Project of Beijing Municipal Commission of Education
