期刊文献+

直升机减速器润滑系统应急技术研究 被引量:5

Emergency Technology Study of Helicopter Reducer Lubrication System
下载PDF
导出
摘要 直升机减速器润滑系统出现故障,齿轮轴承将处于无润滑油工作状态,使减速器在短时间内破坏,造成灾难性的后果。对直升机减速器润滑系统多种应急技术方案进行分析,指出这些方案的优点与缺陷,提出了更为全面更为先进的解决思路,如选用热强度高的材料;对传动元件进行表面改性;采用应急润滑系统;用油气润滑代替油雾润滑;使用硫系与磷系复合添加剂或其他在高速冲击和低速高扭矩条件下均具有良好抗磨性能的复合添加剂。 If the lubrication system of helicopter reducer is destroyed, gears and bearings will be at the non-lubricating oil work state, which causes the reducer to be damaged in a short time and creates disastrous consequence. Many kinds of emergency technical means of helicopter reducer lubrication system were analyzed, the advantages and defects of these methods were pointed out and some more overall and more advanced ideas were put forward, such as using high strength materials at high temperature, modifying surface properties of transmission components, using emergency lubrication system, using oil-gas lubrication instead of oil-mist lubrication and using composite additives of sulphur and phosphorus or else compound additives of good abrasion resistance in the conditions of high speed impact and low speed high torque.
出处 《润滑与密封》 CAS CSCD 北大核心 2012年第3期94-97,共4页 Lubrication Engineering
基金 国家重点基础研究发展规划项目(973计划)(2007CB607600) 中科院固体润滑国家重点实验室开放基金项目
关键词 直升机 减速器 润滑系统 干运转 应急技术 helicopter reducer lubrication system oil-out operation emergency technology
  • 相关文献

参考文献7

  • 1Dhanasekaran S,Gnanamoorth R.Gear tooth wear in sinteredspur gears under dry running conditions[J].Wear,2008,265:81-87.
  • 2赵振业.航空高性能齿轮钢的研究与发展[J].航空材料学报,2000,20(3):148-157. 被引量:31
  • 3Michael F M,Clark V C,Adam R,et al.Secondary lubricationsystem with injectable additive:US,0261922A1[P].2007-11-15.
  • 4Wilfredo M,Robert F,Timothy L K.Feasibility study of vapor-mist phase reaction lubrication using a thioether liquid[R].NASA/TM 215035,2007.
  • 5Stanley I P,Hans R S,Erwin V Z.Comparison between oil-mistand oil-jet lubrication of high-speed,small-bore,ball bearings[R].NASA/TM210462,2001,8.
  • 6Hohn B R,Michaelis K,Otto H P.Minimised gear lubricationby a minimum oil/air flow rate[J].Wear,2009,266:461-467.
  • 7于敏,戴振东,薄玉奎,薛同博,刘贵龄,董创.提高直升机齿轮传动干运转能力的离子注入技术[J].南京航空航天大学学报,2006,38(1):11-15. 被引量:5

二级参考文献10

  • 1吴运新,汪复兴,程荫芊,唐国翌,陈南平.摩擦表面MoS_2润滑膜的显微结构分析[J].理化检验(物理分册),1996,32(1):16-18. 被引量:3
  • 2并木邦夫.高强度齿车用钢[J].热处理,1998,28(4):227-227.
  • 3托马斯AK 卡尔乎特W.齿轮承载能力计算[M].北京:冶金工业出版社,1979..
  • 4Lewicki D G,Decker H J,Shimski J T.Development of full-scale transmission testing to evaluate advanced lubricants[C]//Advancing Power Transmi-ssion into the 21st Century; Proceedings of the 6th International Power Transmission and Gearing Conference,Scottsdale,AZ.New York:American Society of Mechanical Engineers,1992,1(A94-2033707-37):291-297.
  • 5Abdelmaseh M,Orkin C,Sikorski E.Seasprite oil out transmission testing[C]//Annual Forum Proceedings-American Helicopter Society.Saint Louis,USA:AHS,1993(49):1457-1470.
  • 6Zhang T,Zhang H,Ji C,et al.Industrialization of MEVVA source ion implantation[J].Surf Coat Technol,2000(128/129):1-8.
  • 7Heiniche G.Tribochemistry[M].Berlin:Akademie-Verlag,1984.
  • 8戴振东,寥自灿,刘贵龄,杨生荣.直升机传动系统干运转能力的研究[J].机械科学与技术,1999,18(2):255-258. 被引量:6
  • 9范炯,戴振东,姜澄宇.多功能摩擦试验机的研制与应用[J].南京航空航天大学学报,2000,32(4):405-409. 被引量:16
  • 10王钧石,柳襄怀,王曦,陈元儒.等离子体源离子注入表面改性研究及应用[J].材料热处理学报,2002,23(1):25-27. 被引量:11

共引文献34

同被引文献30

  • 1DHANASEKARAN S, GNANAMOORTHY R. Gear tooth wear in sintered spur gears under dry running conditions [ J ]. Wear,2008 ( 265 ) : 81-87.
  • 2MORALES W, HANDSCHUH R F, KRANTZ T L. Fea- sibility study of vapor-mist phase reaction lubrication u- sing a thioether liquid[ R]. NASA/TM-215035,2007.
  • 3MULLEN M F, COOPER C V, GLASSER A R, et al. Secondary lubrication system with injectable additive: US ,2007/0261922A1 [ P]. 2007-11-15.
  • 4MATUMURA H, YOSHIMURA H, OKAZAKI T. Oil/air lubrication system: US, 2009/0026016 A1 [ P]. 2009-01- 29.
  • 5PINEL S I, SIGNER H R, ZARETSKY E V. Comparison between oil-mist and oil-jet lubrication of high-speed, small-bore, angular-contact ball bearings [ R ]. NASA/ TM-210462, 2001.
  • 6HOHN B R, MICHAELIS K, OTTO H P. Minimised gear lubrication by a minimum oil/air flow rate [ J ]. Wear, 2009,266 : 461-467.
  • 7WU C H, KUNG Y T. A parametric study on oil/air lu- brication of a high-speed spindle [ J ]. Precision Engi- neering,2005,29 : 162-167.
  • 8Dhanasekaran S,Gnanamoorthy R. Gear tooth wear in sintered spur gears under dry running conditions[J]. Wear,2008,265 : 81 -87.
  • 9Morales W ,Handsehuh R F ,Krantz T L. Feasibility study of va- por-mist phase reaction lubrication using a thioether liquid [ R ]. NASA/TM -215035,2007.
  • 10Mullen M F, Cooper C V, Glasser A R, et al. Secondary lubrication system with injectable additive : US, 0261922A1 [P].2007-11-15.

引证文献5

二级引证文献9

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部