摘要
采用热天平研究了贵州褐煤、三江原煤及其拔头半焦的燃烧行为,考察了粒径和升温速率对样品着火点和燃烧稳定性的影响。减小样品的粒径可显著降低样品的着火点,改善样品的燃烧性能,在粒径100～120目和升温速率25℃/min下,样品的燃烧稳定性最好。根据Coats-Redfern方法求解燃烧反应动力学参数。燃烧反应动力学分析表明,三种样品的热天平燃烧反应均为一级反应,并得到了实验样品的燃烧反应动力学参数,表观活化能E和指前因子A。贵州褐煤的活化能为100.0～163.6 kJ/mol,三江原煤的活化能为73.4～161.2 kJ/mol,三江煤焦的活化能为68.3～178.1 kJ/mol。
A systematic research on the combustion characteristics of Guizhou lignite,Sanjiang coal and Sanjiang char had been done using STA 409C Netzh-thermogravimetric analyzer.The effects of particle diameter and heating rate on maximum mass loss rate,ignition point and combustibility were analyzed.The decrease of particle diameter can reduce the ignition point and improve the combustibility.When particle size is 100～120 mesh and heating rate is 25℃/min,the combustibility of samples is the best.The combustion reactions are one-order reaction and kinetics parameters（activation energy E and frequency factor A） were obtained by the method of Coats-Redfern basing on experimental data.Activation energy of Guizhou lignite,Sanjiang coal and Sanjiang char are 100.0～163.6kJ/mol,73.4～161.2kJ/mol,68.3~178.1kJ/mol.
出处
《燃料化学学报》
EI
CAS
CSCD
北大核心
2012年第5期513-518,共6页
Journal of Fuel Chemistry and Technology
基金
国家自然科学基金(20876048)
国家重点基础研究发展规划(973计划
2010CB227006)
关键词
粒径
燃烧
着火点
热重分析
particle diameter
combustion
ignition point
thermogravimetric analysis
