期刊文献+

液-液流动边界层传质系数的实验研究

Experimental Research on Mass Transfer Coefficient in Liquid-Liquid Flow Boundary Layer
下载PDF
导出
摘要 为了研究冶金反应器内渣-金界面的传质,设计了研究液-液流动边界层传质实验.实验在保证油-水界面稳定的情况下,研究了苯甲酸钠示踪物质在油-水界面的传质现象.通过改变水流量Q(0.44~1.60m3/h),利用电导率仪测量苯甲酸钠示踪物质在水中的浓度变化,实验确定了液-液界面流动边界层传质系数的准数方程式,并尝试性地给出了液体黏度以及表面张力与传质系数之间的准数关系式.实验结果与液体流过平板边界层的传质过程作了比较讨论. Experiment research concerning the mass transfer of flowing boundary layer on a liquid-liquid interface was performed to discuss the mass transfer on the molten slag-metal interface in metallurgical reactor.The mass transfer phenomenon of sodium benzoate on the oil-water interface was analyzed in the condition of keeping oil-water interface flat.The concentration change of sodium benzoate with time in water was measured by conductivity meter when the volume flow of water varied from 0.44 to 1.60 m3/h.A dimensionless number equation with respect to the mass transfer coefficient of flowing boundary layer on the liquid-liquid interface was obtained.Then,a dimensionless number equation between the mass transfer coefficient and viscosity as well as surface tension was given tentatively.The results were compared with the mass transfer of boundary layer in the case of fluid flowing through a flat.
出处 《东北大学学报(自然科学版)》 EI CAS CSCD 北大核心 2012年第5期673-676,680,共5页 Journal of Northeastern University(Natural Science)
基金 国家自然科学基金资助项目(51104037 50774019)
关键词 渣-金界面 边界层传质 传质系数 准数关系式 水模型 slag-metal interface mass transfer on boundary layer mass transfer coefficient dimensionless number equation water model
  • 相关文献

参考文献12

  • 1Singh V, Lenka S N, Ajmani S K, et al. A novel bottom stirring scheme to improve BOF performance through mixing and International, mass transfer modelling [ J ]. ISIJ 2009,49(12):1889 - 1894.
  • 2Kiyonobu S, Kimihisa I T O. Measurement of the volumetric mass transfer coefficient of gas-stirred vessel under reduced pressure [ J ]. ISIJ International, 1995,35 (11) :1348- 1353.
  • 3Akdogan G, Eric R H. Model study on mixing and mass transfer in ferroalloy refining processes [ J ]. Metallurgical and Materials Transactions, 1999,30B :231 - 239.
  • 4Kim S H, Fruehan R J, Guthrie R I L. Physical model studies of slag/metal reactions in gas-stirred ladles- determination of critical gas flow rate [ J ]. Iron & Steel Maker, 1993,20(11) :71 - 76.
  • 5Nakanishi K, Kato Y, Nozaki T, et al. Cold model study on the mixing rate of slag and metal bath in Q-BOP[J]. ISIJ International, 1980,66(9) : 1307 - 1316.
  • 6Paul S, Ghosh D N. Model study of mixing and mass transfer rates of slag-metal in top and bottom blown eonverters[Jl. Metallurgical Transactions B, 1986,17(9) :461 - 469.
  • 7Singh R P, Ghosh D N. Cold model study of mixing and mass transfer in LBE process of steel-making [ J ]. ISIJ International, 1990,30(11):955-960.
  • 8Mietz J, Schneider S, Oeters F. Emulsification and mass transfer in ladle metallurgy [ J ]. Steel Research International, 1991,62 ( 1 ) : 10 - 15.
  • 9Wei T, Oeters F. A model test for emulsion in gas-stirred ladles[ J ]. Steel Research International, 1992,63 (2) : 60 - 68.
  • 10Savolainen J, Fabritius T, Mattila O. Effect of fluid physical properties on the emulsification [ J ]. ISIJ International, 2009,49(1) :29 - 36.

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部