摘要
利用超高分子量聚乙烯(PE-UHMW)粉末代替传统材料成型塑烧板基板,通过研究冷压压力对PE-UHMW粉末坯体孔隙率的影响及烧结颈随烧结时间的演变,确定了采用粉末压制烧结成型时成型压力应小于6 MPa,烧结时间应为30 min左右。通过对制件性能的检测及微观形貌的观察,验证了该参数成型的塑烧板基板符合孔径约为30～40μm,孔隙率大于40%,拉伸强度大于2 MPa的使用要求。
PE-UHMWPE powder was used to forming the substrate of sinter plate instead of the conventional material. The influence of cold compress pressure on porosity of the PE-UHMW powder was studied, and the development of sintering neck with sintering time was observed, then two key parameters that the forming pressure should be less than 6 MPa, and the sintering time should be about 30 min were determined by the experiments above-mentioned. Through properties detection and microstructure observation, the substrate of sinter plate produced under the key parameters above-mentioned could meet the requirements that pore size was 30-40 μ m, porosity was greater than 40%, and tensile strength was above 2 MPa.
出处
《工程塑料应用》
CAS
CSCD
北大核心
2012年第6期36-39,共4页
Engineering Plastics Application
基金
国家自然科学基金重大研究计划(91123012)
国家自然科学基金项目(50475140)
关键词
PE—UHMW
塑烧板基板
粉末压制烧结
模具设计
成型工艺
性能检测
PE-UHMW
substrate of the sinter plate
powder compress and sintering
mould design
moulding process
property detection
