摘要
采用微波辅助原位氧化还原法制备长径比均匀的银纳米棒,研究了制备条件参数如催化剂浓度、表面活性剂与先驱体浓度比率等因素对制备银纳米材料的形貌的影响。以这些银纳米棒作为导电填料制备印刷用导电油墨,研究了填料含量、纳米棒及纳米粒子的比率对导电油墨的电导率、附着力、老化性能的影响。结果表明,当晶体生长催化剂NaCl与AgNO3的摩尔比为1∶5时,得到的银纳米材料中纳米棒比例达95%以上。对导电油墨的性能研究表明,当填料中银纳米棒比例为95%时得到的导电胶具有最低的渗滤阈值,为62%,同时经过80℃、85%RH老化环境老化500h后导电油墨的体积电阻率上升不超过10%。
Microwave-assisted method was used to prepare Ag nanorods with uniform sizes.The influence of parameters such as the concentration of catalyst,the concentration ratio of surfactant and precursor was studied.A novel kind of conductive inkjet was prepared by using these Ag nanoreods as conductive filler.The performances of the conductive inkjet such as percolation threshold of the filler,bonding strength and ageing resistant were studied.The results show that a mixture with 95% Ag nanorods can be obtained when the concentration ratio of AgNO3 to NaCl reaches to 5∶1.The percolation threshold of the conductive inkjet is 62% when 95% Ag nanorods are included in the filler.The ageing resistant measurements results show that the changes of the electrical conductivity of conductive inkjet are less than 10% after ageing under 85%RH and 80 ℃ condition for 500 h.
出处
《复合材料学报》
EI
CAS
CSCD
北大核心
2012年第4期143-147,共5页
Acta Materiae Compositae Sinica
关键词
导电油墨
银纳米棒
填料阈值
耐老化性能
conductive inkjet； Ag nanorods； percolation threshold； ageing resistant；
