期刊文献+

带开关电容网络的交错并联高增益Boost变换器 被引量:33

Interleaved High Gain Boost Converter With Switched Capacitor Network
下载PDF
导出
摘要 提出了一种新颖的带开关电容网络的交错并联高增益Boost变换器,对其工作原理和特性进行了详细分析。变换器的拓扑在传统两相交错并联Boost变换器的基础上增加了一个二极管和两个电容,并进行改进,构成了开关电容网络。与传统两相交错并联Boost变换器相比,新拓扑不仅输入电流纹波减小,而且在相同的占空比下实现了更高的电压增益,开关器件的电压应力得以减小。因此,新拓扑非常适合应用于低压输入、高压输出的场合,如燃料电池、光伏发电等系统。最后,通过实验验证了理论分析的正确性。 A novel interleaved high gain Boost converter with switched capacitor network is proposed in this paper. Operation principle and property of this converter are analyzed. Based on the traditional two phase interleaved Boost converter, a diode and two capacitors are added, and forms into a switched capacitor network. Compared with the traditional two phase interleaved Boost converter, the ripple of the input ripple current is still low, but the voltage gain is higher and the voltage stresses of the switches are reduced. Consequently, the new topology is very suitable for the application, such as the fuel cell power system and photovoltaic system, in which it has low input voltage but high output voltage. Finally, the experiment is built to verify the theoretical analysis.
出处 《电工技术学报》 EI CSCD 北大核心 2012年第11期153-159,共7页 Transactions of China Electrotechnical Society
基金 输配电装备及系统安全与新技术国家重点实验室自主研究项目(2007DA10512711205)
关键词 开关电容网络 交错并联Boost变换器 电压增益 电压应力 Switched capacitor network, interleaved Boost converter, voltage gain, voltage stress
  • 相关文献

参考文献11

  • 1BP statistical review of word energy[R]. Geneva BP, 2005, 6.
  • 2李瑛,王林山.燃料电池[M].北京:冶金工业出版社,2005.
  • 3Pan Chingtsai, Lai Chingming. A high efficiency high step-up converter with low switch voltage stress for fuel cell system applications[J]. IEEE Transactions on Industrial Electronics, 2010, 57(6): 1998-2006.
  • 4Palma L, Todorovic M H, Enjeti P. A high gain Transformer-less DC-DC converter for fuel-cell applications[C]. Power Electronics Specialists Conference 2005.2514-2520.
  • 5Yang Lungsheng, Liang Tsorngjuu, Chen Jiannfuh. Transformerless DC-DC converters with high step-up voltage gain[J]. IEEE Transactions on Industrial Electronics, 2009, 56(8): 3144-3152.
  • 6Thounthong P, Sethakul P, Davit B. Modified 4 phase interleaved fuel cell converter for high-power high-voltage applications[C]. IEEE International Conference on Industrial Technology, 2009:1-6.
  • 7Huang B, Sadli I, Martin J P, et al. Design of a high power high step-up non-isolated DC-DC converter for fuel cell applications[C]. IEEE Vehicle Power and Propulsion Conference, 2006: 1-6.
  • 8Jung Min Kwon, Eung Ho Kim, Bong Hwan Kwon, et al. High-efficiency fuel cell power conditioning system with input current ripple reduction[J]. IEEE Transactions on Industrial Electronics, 2009, 56(3): 826-834.
  • 9De Caro S, Testa A, Triolo D, et al. Low input current ripple converters for fuel cell power units[C].European Conference on Power Electronics and Applications, 2005: 1-10.
  • 10姚刚,沈燕群,李武华,何湘宁.一种新型的有源交错并联Boost软开关电路[J].中国电机工程学报,2005,25(10):65-69. 被引量:45

二级参考文献15

  • 1Lee P W, Lee Y S, David K W.Cheng et al. Steady-state analysis of an interleaved boost converter with coupled inductors[ J ]. In IEEE Transactions on Industrial Electronics, August 2000,47(4 : 785 - 795.
  • 2Braga H A C, Barbi I. A 3-kW unity-power-factor rectifier based on a two-cell boost converter using a new parallel-connection technique[ J ].IEEE Trans. Power Electron, 1999,14 : 209 - 217.
  • 3Miwa B A, Otten D M, Schlecht M F. High efficiency power factor correction using interleaving techniques[ C ]. Proceedings of APEC'92 , Westin Copley Plaza Hotel, Boston, Massachusetts 1992, 2 : 557 - 568.
  • 4Lai J S, Chen D. Design consideration for power factor correction boost converter operating at the boundary of continuous conduction mode and discontinuous conduction mode[ C ], in Proc. IEEE APEC'93,San Diego, CA, 993, 3 : 267 - 273.
  • 5Cheng D K W, Liu X C, Lee Y S. A new modified boost converter with ripple free input current by using coupled inductors[ C ], in Proc .IEE Int. Conf. Power Electronics and Variable Speed Drives,London, U.K., Sept. 1998, 592 - 599.
  • 6Balogh L, Redl R. Power-factor correction with interleaved boost converters in continuous-inductor-current mode[ C ], in Proc. IEEE APEC'93, San Diego, CA, Mar. 1993.168 - 174.
  • 7de Oliveira Stein, Pinheiro C M, Hey J R et al. A ZCT auxiliary commutation circuit for interleaved boost converters operating in critical conduction mode[ J ]. in IEEE Transactions on Power Electronics, 2002, 17(6) : 954 - 962.
  • 8Elmore M S. Input current ripple cancellation in synchronized,parallel connected critically continuous boost converters[ C ]. in Proc.IEEE Appl. Power Electron, Conf., 1996, 52 - 158.
  • 9Chart C H, Pong M H. Input current analysis of interleaved boost converters operating in discontinuous-inductor current mode[ C ], in IEEE Power Electron. Spec. Conf., 1997,392 - 398.
  • 10Chart C H, Pong M H. Interleaved boost power factor corrector operating in discontinuous-inductor-current mode[ C ], in PCC-Nagaoka, 1997,13 : 405 - 410.

共引文献44

同被引文献270

引证文献33

二级引证文献285

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部