期刊文献+

臭氧催化氧化工艺深度处理印染废水 被引量:39

Advanced treatment of dyeing wastewater using catalytic ozonation process
原文传递
导出
摘要 采用正交实验对催化剂NiO/γ-Al2O3的制备条件进行优化,并探讨臭氧催化氧化法对于印染废水的深度处理效能。结果表明,最优的催化剂制备条件为:浸渍液浓度为3%、浸渍时间为4 h、灼烧温度为450℃、灼烧时间为3 h。臭氧催化氧化反应15 min时,COD浓度由84.22 mg/L降低至50.00 mg/L以下;氨氮浓度由10.88 mg/L降低至5.01 mg/L;色度去除率达到69%,明显高于单纯臭氧氧化的反应效率。 The preparation method of NiO/γ-Al2O3 as catalyst was optimized through orthogonal test and the advanced treatment efficiency of dyeing wastewater through catalytic ozonation process was also discussed.Results showed that the optimal catalyst preparation conditions are: impregnating solution concentration of 3%,immersion time of 4 h,burning temperature of 450℃ and burning time of 3 h.When kept ozone oxidation of 15 min,COD concentration decreased from 84.22 mg/L to 50.00 mg/L,the NH3-N concentration decreased from 10.88 mg/L to 5.01 mg/L,and the chromaticity removal rate reached to 69%,which showed higher reaction efficiency than that of single ozone oxidation process.
出处 《环境工程学报》 CAS CSCD 北大核心 2013年第8期2873-2876,共4页 Chinese Journal of Environmental Engineering
基金 国家水体污染控制重大专项(2012ZX07201003) 教育部新世纪优秀人才项目(NCET-12-0156)
关键词 臭氧催化氧化 深度处理 印染废水 catalytic ozonation advanced treatment dyeing wastewater
  • 相关文献

参考文献18

二级参考文献91

共引文献166

同被引文献467

引证文献39

二级引证文献363

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部