摘要
通过熔融浸渍法制作了聚丙烯(PP)预浸料坯带。采用正交试验,研究了玻纤增强PP复合管材缠绕成型过程中几个主要加工温度参数对其性能的影响。结果表明,通道加热温度、热风枪加热温度、芯模温度对复合管材的层间剪切强度(F sbs)和环向拉伸强度(σ环)有显著影响。其中,热风枪温度对F sbs影响较大,而芯模温度对σ环影响较大。在预热通道温度200℃,热风枪温度260℃,芯模温度140℃的最优工艺条件下,管材的F sbs达到43.69 MPa,σ环达到了589 MPa。
Polypropylene（PP） prepreg tape was produced by using melt impregnation method.Effects of several processing temperatures on properties of filament winding of glass fiber reinforced polypropylene pipe were studied by orthogonal experiments. The results show that temperatures of heated chamber, hot air gun and mandrel have significant impact on interlaminar shear strength （Fsbs） and hoop tensile strength （σring） of PP composite pipe.Among them, hot air gun temperature has greater impact on Fsbs, meanwhile, mandrel temperature has greater influence on σring.Based on optimal process parameters of preheat channel temperature 200 ℃, hot air gun temperature 260 ℃, mandrel temperature 140 %, Fsbs and σring are 43.69 MPa and 589 MPa respectively.
出处
《工程塑料应用》
CAS
CSCD
北大核心
2013年第10期56-59,共4页
Engineering Plastics Application
关键词
缠绕成型
玻纤增强聚丙烯
层间剪切强度
环向拉伸强度
filament winding
glass fiber reinforced polypropylene
interlaminar shear strength
hoop tensile strength
