期刊文献+

Si对Y_(0.3)Ca_(0.7)TiO_3:Pr^(3+)发光性质的影响

The Effect of Si on the Luminescent Properties of Y_(0.3)Ca_(0.7)TiO_3:Pr^(3+)
原文传递
导出
摘要 采用高温固相反应合成Y0.3Ca0.7Ti x Si1-x O3∶Pr3+0.0015(x=0.1,0.3,0.5,0.7,0.9)红色系列粉末状发光材料。经X射线衍射分析产物为两相,分别为CaTiO3和Ca4Y6O(SiO4)6。检测了材料的激发光谱和发射光谱。发射光谱的峰值位于613 nm,对应于Pr3+的1D2-3H4跃迁。随着Si含量值的增大,激发光谱在340 nm附近的吸收增强,同时提高发射光谱的强度,当Si含量为0.3时,强度达到最大值;但过量硅的加入会导致发射光谱强度下降。 The samples of Y0.3Ca0.7TixSi1-xO3:Pr0.001s^3+ ( x = 0.1, 0. 3, 0.5, 0.7,0.9 ) were synthesized by solid state reaction. The X -ray diffraction analysis showed that the products were composited of two phases,CaTiO3 and Ca4Y60( SiO4 ) 6. The excitation and emission spectra of samples were investigated and it was found that the emission spectrum is dominated by the red peaks at 613nm, corresponding to the transition I D2--~3 Ha of Pr3~. As the silicon content increasing, the absorption of samples in 340nm and the intensity of emission spectrum were both increased. When the silicon content was 0.3, the intensity of emission got the highest value ; but excessive silicon will lead to a decreasing of emission intensity.
出处 《稀土》 EI CAS CSCD 北大核心 2013年第5期31-34,共4页 Chinese Rare Earths
基金 内蒙古自治区科技创新引导奖励资金计划项目资助(201207) 包头市重点自主创新产品认定项目资助(2011C1002-23)
关键词 钛酸钙 SI 发光材料 calcium titanate silicon luminescent material
  • 相关文献

参考文献11

二级参考文献111

共引文献152

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部