摘要
Current researches have not yet found the effect law of the cutter parameters and machining parameters on the interference in gear slicing, the interference between the cutter and machined gear often happens because the appropriate cutter parameters and machining parameters cannot be set, which reduces the gear machining accuracy. The relative position between the major flank face and edge-sweeping surface, distribution law of the interference area in forming process of edge-sweeping surface, and effect law of relative positions among edge-sweeping surfaces on the interference are studied by graphical analysis. The effect law of the cutter parameters and machining parameters on the interference is found. The effect law shows that the interference in gear slicing can be controlled when the relief angle measured on the top edge and feed of every rotation are chosen respectively larger than 9~ and smaller than 0.15 mrn/r. An internal helical gear is sliced with the spur slice cutter and the cutter parameters and machining parameters are set based on above the effect law. The machined gear is measured in Gear Measuring Center and the detection result shows that the comprehensive accuracy reaches GB/T Class 7, where some reach GB/T Class 6. The result can meet the gear machining accuracy requirement and shows that the effect law found is valid. The problem of the interference in gear slicing is solved and the gear machining accuracy can be improved.
Current researches have not yet found the effect law of the cutter parameters and machining parameters on the interference in gear slicing, the interference between the cutter and machined gear often happens because the appropriate cutter parameters and machining parameters cannot be set, which reduces the gear machining accuracy. The relative position between the major flank face and edge-sweeping surface, distribution law of the interference area in forming process of edge-sweeping surface, and effect law of relative positions among edge-sweeping surfaces on the interference are studied by graphical analysis. The effect law of the cutter parameters and machining parameters on the interference is found. The effect law shows that the interference in gear slicing can be controlled when the relief angle measured on the top edge and feed of every rotation are chosen respectively larger than 9~ and smaller than 0.15 mrn/r. An internal helical gear is sliced with the spur slice cutter and the cutter parameters and machining parameters are set based on above the effect law. The machined gear is measured in Gear Measuring Center and the detection result shows that the comprehensive accuracy reaches GB/T Class 7, where some reach GB/T Class 6. The result can meet the gear machining accuracy requirement and shows that the effect law found is valid. The problem of the interference in gear slicing is solved and the gear machining accuracy can be improved.
基金
supported by National Natural Science Foundation of China(Grant No.51175376)
