期刊文献+

滑石粉在阻燃聚丙烯土工格栅中的应用研究 被引量:5

Research on Application of Talc in Flame Retarded Polypropylene Used for Geo-Grid
下载PDF
导出
摘要 利用极限氧指数(LOI)仪、酒精喷灯燃烧实验、差示扫描量热分析(DSC)、热重分析(TG)、锥形量热仪及力学性能测试研究了滑石粉用量对阻燃聚丙烯(PP)土工格栅力学性能、熔体流动速率(MFR)、阻燃性能和热稳定性的影响,并对其作用机理进行了分析。结果表明,在六溴环十二烷协同三氧化二锑的阻燃体系下,滑石粉的加入降低了阻燃PP土工格栅的力学性能、阻燃性能和热稳定性,但提高了材料的MFR,使其加工性能得到改善。添加质量分数为3%的滑石粉后,阻燃PP土工格栅的拉伸强度及断裂伸长率分别降低2.72%和23.33%,MFR和热释放速率峰值分别增加4.28%和6.22%。DSC和TG分析表明,滑石粉可以提高阻燃PP土工格栅的结晶度,但使其熔融焓及热稳定性下降,其中添加质量分数为3%的滑石粉后,阻燃PP土工格栅的结晶度提高了10.11%,熔融焓降低了37.38%,PP在空气气氛下的初始分解温度比氮气气氛降低了60℃左右。 The effects of talc on the mechanical properties, melting flow rate, flame retardant properties and thermal stabilities of flame retarded polypropylene used for geo-grid were studied and the mechanism of talc was analyzed by limited oxygen index, alcohol blow lamp test, differential scanning calorimeter, thermo-gravimetric analyzer, cone calorimeter and mechanical performances test. The results show that in the flame retardant system of hexahromocyclododecane and antimony trioxide, the mechanical properties and flame retardant properties and thermal stabilities of flame retarded polypropylene used for geo-grid are decreased while the melting flow rate and processability are improved by adding talc. When mass fraction of talc is 3%, the tensile strength and elongation at break of flame retarded polypropylene used for geo-grid are reduced by 2.72% and 23.33% respectively, while melting flow rate and heat release rate peak are increased by 4.28% and 6.22% respectively. Differential scanning calorimetry and thermal gravimetric analysis indicate that the crystallinity of flame retarded polypropylene used for geo-grid is increased by 10.11% and melting enthalpy is decreased by 37.38% when mass fraction of talc is 3%, the thermal stabilities of flame retarded polypropylene used for geo-grid is decreased by adding talc, significantly, the onset decomposition temperature of polypropylene under air conditions are decreased about 60℃ comparing to that under N2 conditions.
出处 《工程塑料应用》 CAS CSCD 北大核心 2014年第1期107-111,共5页 Engineering Plastics Application
基金 国家自然科学基金资助项目(51306097) 湖南省科技厅重点资助项目(2013SK2004) 山东省自然科学基金项目(ZR2012EMQ008)
关键词 聚丙烯 土工格栅 溴系阻燃剂 滑石粉 力学性能 阻燃性能 热稳定性 熔体流动速率 polypropylene geo-grid brominated flame retardant talc mechanical property flame retardant property thermal stability melting flow rate
  • 相关文献

参考文献15

  • 1Xu Riqing , Wang Jingchun. Geosynthetics applicationtechnology[M]. Beijing:Chemical Industry Press,2005.
  • 2Zhang Jun, Ji Kuijiang, Xia Yanzhi. Polymer combustion and fire-retardant technology[M]. Beijing:Chemical Industry Press,2005.
  • 3颜龙,王勇,卜爱华,张军.几种阻燃剂对格栅用HDPE的阻燃及协效作用研究[J].上海塑料,2012,40(4):15-20. 被引量:5
  • 4Laoutid F, Bonnaud LI L, Alexandre MEL, et al. New prospectsin flame retardant polymer materials:From fundamentals tonanocomposites[J]. Materials Science and Engineering:R:Reports,2009,63(3):100-125.
  • 5Weon J I, Sue H J. Mechanical properties of talc and CaC〇3-reinforced high-crystallinity polypropylene composites[J]. J MaterSci,2006,41(8):2 291-2300.
  • 6刘婷婷,张培萍,吴永功.层状硅酸盐矿物填料在聚合物中的应用及发展[J].世界地质,2001,20(4):360-363. 被引量:7
  • 7De Medeiros E, Tocchetto R, De Carvalho L,et al. Nucleatingeffect and dynamic crystallization of a poly (propylene) / talcsystem[J]. Journal of Thermal Analysis and Calorimetry, 2001,66(2):523-531.
  • 8Weidenfeller B, Hofer M, Schilling F R. Thermal conductivity,thermal diffusivity, and specific heat capacity of particle filledpolypropylene [J].Composites Part A:Applied Science andManufacturing,2004,35(4):423-429.
  • 9Cl ere L,Ferry L, Leroy E, et al. Influence of talc physicalproperties on the fire retarding behaviour of (ethylene-vinyl acetatecopolymer / magnesium hydroxide / talc) composites[J]. PolymerDegradation and Stability, 2005,88(3):504-511.
  • 10Durin . France A, Ferry L, Lopez Cuesta J M,et al. Magnesiumhydroxide / zinc borate / talc compositions as flame - retardantsin EVA copolymer[J]. Polymer International, 2000,49(10):1 101-1 105.

二级参考文献25

  • 1马懿,宗明.PP/EPDM/云母共混复合材料的研究[J].中国塑料,1996,10(1):10-16. 被引量:8
  • 2赵伟,王丽.硼酸锌在LDPE阻燃中的协效作用[J].塑料科技,2006,34(1):40-43. 被引量:24
  • 3黄青松,张军,杨蕾,王立春.阻燃LDPE的研究[J].现代塑料加工应用,2006,18(1):5-8. 被引量:9
  • 4田计青,贾润礼.聚乙烯复合阻燃体系的研究及应用进展[J].塑料助剂,2006(6):6-10. 被引量:4
  • 5J. M.Dealy and K.F. Wissbrun. Melt Rheology and Its Role in Plastics Processing[ M ]. Van Nostrand Reinhold, NewYork, 1990.
  • 6H.H. Winter. Collaborative Study on the Relation Between Film Blowing PerIormance and Rheological Properties of Two Low-Density and Two High-Density Polyethylene Samples[J]. Pure and Applied Chemistry, 1983, 55: 943.
  • 7J. L. Throne. Thermoforming[M]. Hanser Publishers,Munich, 1987.
  • 8J. J. Morad. High Melt Strength Polypropylene for Large Part Thermoforming[R]. ANTEC'95, 1995:783.
  • 9Shivendra K. Goyal. The Influence of Polymer Structure on Melt Strengh Behavior of PE Resins[J]. Plastics Engineering, 1995, 51(2):25.
  • 10H.C. Lau. S.N.Bhattacharya.and G. J. Field.Melt of Polypropylene: Its Relevance to Thermoforming[J]. Polymer Engineering and Science, November, 1998, 38(11): 1 915-1 923.

共引文献39

同被引文献45

  • 1薛敏.塑料土工格栅的生产开发[J].现代塑料加工应用,2004,16(6):58-61. 被引量:5
  • 2Weon J, Sue H. Mechanical properties of talc-and CaCO3-reinforced bigh-erystallinity polypropylene composites[J]. Journal of Materials Science, 2006,41 (8):2 291-2 300.
  • 3Rothon R N. Particulate-filled polymer composites[M]. Shrewsbury: iSmithers Rapra Publishing, 2003. .
  • 4Weidenfeller B, H6Fer M, Schilling F R. Thermal conductivity, thermal diffusivity, and specific heat capacity of particle filled polypropylene[J]. Composites Part A:Applied Science and Manufacturing, 2004,35(4):423429.
  • 5Avella M, Cosco S, Di Lorenzo M L, et al. Influence of CaCO3 nanoparticles shape on thermal and crystallization behavior of isotaetic polypropylene based nanocomposites[J]. Journal of Thermal Analysis and Calorimetry, 2005,80(1): 131-136.
  • 6Eiras D, Pessan L A. Mechanical properties of polypropylene / calcium carbonate nanocomposites[J]. Materials Research,2009, 12(4):517-522.
  • 7Chen Xiaolang , Yu Jie, He Min, et al. Effects of zinc borate and microcapsulated red phosphorus on mechanical properties and flame retardancy of polypropylene/magnesium hydroxide composites[J]. Journal of Polymer Research, 2009,16(4):357-362.
  • 8Zhou Zhen, Wang Shifeng, Zhang Yong, et al. Effect of different carbon fillers on the properties of PP composites:Comparison of carbon black with multiwalled carbon nanotubes[J]. Journal ofApplied Polymer Science, 2006, 102(5):4 823-4 830.
  • 9Bregoli L, Chiarini F, Gambarelli A, et al. Toxicity of antimony trioxide nanoparticles on human hematopoietic progenitor cells and comparison to cell lines [J]. Toxicology, 2009,262(2): 121-129.
  • 10Laoutid F, Bormaud L I L, Alexandre M E L, et al. New prospects in flame retardant polymer materials:From fundamentals to nanocomposites[J]. Materials Science and Engineering:R:Reports, 2009,63(3): 100-125.

引证文献5

二级引证文献19

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部