期刊文献+

甲醇水溶液脉动热管的传热特性 被引量:10

Heat transfer characteristics of pulsating heat pipe with aqueous methanol as working fluid
下载PDF
导出
摘要 以体积分数为50%的甲醇水溶液为工质,充液率为50%,对不同倾角和加热功率条件下环路脉动热管的启动性能和稳定运行时的传热性能进行了实验研究。对比分析了甲醇水溶液、无水甲醇和水的传热效果,探讨了甲醇水溶液与水、无水甲醇在启动过程中启动时间、启动温度以及稳定运行时传热热阻、热冷端温差的变化特点。结果表明,在低加热功率条件下,甲醇水溶液45°和90°倾角下的启动方式均为温度渐变型,甲醇水溶液的启动时间比无水甲醇长,但比水短。稳定运行时,甲醇水溶液在90°倾角下加热段温度低于甲醇,且波动较大。在低、中加热功率条件下,甲醇水溶液传热性能优于水和无水甲醇,甲醇水溶液在45°和90°倾角下的最小热阻值分别为0.38℃/W和0.3℃/W。 The experiments on heat transfer characteristics of the start-up and steady operation processes of pulsating heat pipe were conducted using three working fluids at various inclination angles and heat inputs. Water,methanol,and aqueous methanol were used as working fluid with 50%fill ratio. The characteristics were compared and analyzed between aqueous methanol,water,methanol in the start-up and steady operation processes. The type of start-up for aqueous methanol was gradual start-up at low heat inputs and different inclination angles. Start-up time span of aqueous methanol was longer than that of methanol,but shorter than that of water. In a steady operation process,the temperature of aqueous methanol in heating section was lower than that of methanol,and fluctuation of temperature was larger. Aqueous methanol showed the best thermal performance among them at low and medium heat inputs. The minimum thermal resistances of aqueous methanol were 0.38℃/W and 0.3℃/W at the angle 45°and 90°,respectively.
出处 《化工进展》 EI CAS CSCD 北大核心 2014年第12期3170-3175,共6页 Chemical Industry and Engineering Progress
基金 天津市自然科学基金项目(10JCYBJC08100)
关键词 甲醇水溶液 甲醇 脉动热管 倾角 传热性能 aqueous methanol methanol pulsating heat pipe inclination angle heat transfer performance
  • 相关文献

参考文献16

  • 1Akachi H, Polasek F, Stulc E Pulsating heat pipes[C]//5th Intemational Heat Pipe Symposium, Melbourne, Australia, 1996: 208-217.
  • 2Khandekar S, Groll M. An insight into thermo-hydrodynamic coupling in closed loop pulsating heat pipes[J]. International Journal of ThermalSeiences, 2004, 43: 13-20.
  • 3Charoensawan P, Khandekar S, Groll M, et al, Closed loop pulsating heat pipes: Part A: Parametric experimental investigations[J]. ThermalEngineering, 2003, 23 (16): 2009-2020.
  • 4Yuan D, Qu W, Ma T. Flow and heat transfer of liquid plug and neighboring vapor slugs in a pulsating heat pipe[J]. International Journal of Heat and Mass Transfer, 2010, 53 ( 7 ): 1260-11268.
  • 5Zuo Z J, North M T, Wert K L. High heat flux heat pipe mechanism for cooling of electronics[J]. Components and Packaging Technologies, 1EEETransactions, 2001, 24 (2): 220-225.
  • 6Holley B, Faghri A. Analysis of pulsating heat pipe with capillary wick and varying channel diameter[J]. International Journal of Heat and Mass Transfer, 2005, 48 (13): 2635-2651.
  • 7Song Y, Xu J. Chaotic behavior of pulsating heat pipes[J]. International Journal of Heat and Mass Transfer, 2009, 52 (13): 2932-2941.
  • 8Sarangi R K, Rane M V. Experimental investigations for star up and maximum heat load of closed loop pulsating heat pipe[J]. Procedia Engineering, 2013, 51: 683-687.
  • 9史维秀,李惟毅,潘利生,谈西峰,云海涛.乙醇水溶液脉动热管传热特性研究[J].机械工程学报,2011,47(24):117-121. 被引量:18
  • 10隋缘,崔晓钰,韩华,李治华,孙慎德.水-乙醇混合工质振荡热管的传热特性研究[J].制冷学报,2014,35(3):50-57. 被引量:6

二级参考文献47

  • 1屈健,吴慧英,唐慧敏.微小型振荡热管的流动可视化实验[J].航空动力学报,2009,24(4):766-771. 被引量:14
  • 2曲伟,周岩,马鸿斌.尺度效应对脉动热管启动和运行的影响[J].工程热物理学报,2007,28(1):140-142. 被引量:17
  • 3杨洪海,KHANDEKAR Sameer,GROLL Manfred.单回路闭式脉动热管内流型的实验研究[J].流体机械,2007,35(1):60-63. 被引量:12
  • 4徐荣吉,王瑞祥,丛伟,吴业正.脉动热管实验台的搭建及可视化实验研究[J].流体机械,2007,35(6):59-61. 被引量:11
  • 5H Akachi, F Polasek, P Stulc. Pulsating heat pipe[C]. Andrews J. Proceeding of 5th international heat pipe symposium. Melbourne:Pergamon Elsevier,1996:208-217.
  • 6P Meena, S Rittidech, N Poomsa-ad. Application of closed-loop oscillating heat-pipe with check valves (CLOHP/CV) air-preheater for reduced relative- humidity in drying systems[J]. Applied Energy, 2007, 84(5):553-564.
  • 7A Jiao, X Han, JK Critser, et al. Numerical investigations of transient heat transfer characteristics and vitrification tendencies in ultra-fastcell cooling processes[J]. Cryobiology, 2006,52(3):386-392.
  • 8S Rittidech, W Dangeton, S Soponronnarit. Closed- ended oscillating heat-pipe (CEOHP) air-preheater for energy thrift in a dryer[J]. Applied Energy, 2005, 81(2): 198-208.
  • 9S Rittidech, S Wannapakne. Experimental study of the performance of a solar collector by closed-end oscillating heat pipe(CEOHP)[J]. Applied Thermal Engineering, 2007,27(11-12): 1978-1985.
  • 10S Rittidech, A Donmaung, K Kumsombut. Experimental study of the performance of a circular tube solar collector with closed-loop oscillating heat-pipe with check valve (CLOHP/CV)[J]. Renewable Energy, 2009, 34(10):2234-2238.

共引文献31

同被引文献94

引证文献10

二级引证文献56

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部