期刊文献+

酸性化学镀镍磷合金的动力学机理 被引量:1

Kinetics and Mechanism of Acidic Electroless Ni-P Plating
下载PDF
导出
摘要 通过极化曲线研究了3种不同溶液(阴极液、阳极液和完整镀液)的电化学行为,测定了主盐、还原剂浓度以及镀液p H和体系温度对化学镀镍沉积速率的影响.与直接在镁合金上化学镀镍并使用重量分析法得到的沉积速率相比较发现,完整镀液体系的极化曲线才能真实地反映化学镀镍的沉积过程,其过程不能简单视为由彼此完全独立毫无关联的阴阳极半反应构成.根据Butler-Volmer公式,本化学镀液体系的化学镀镍过程属混合控制,其表观反应活化能为42.89 k J·mol-1. Electrochemical behaviors of electroless nickel (EN) plating in three systems, namely, cathodic, anodic and complete bath solutions were investigated by polarization methods. The curves in the complete baths were not entirely consistent with those expected from a combination of the anodic and cathodic polarization curves, which implies that the anodic and cathodic reactions of the EN plating are interdependent. The effects of concentration of nickel ions, hypophosphite and pH on the polarization parameter and deposition rate in a complete bath were also discussed and compared by performing electrochemical and gravimetrical measurements. Based on these variations in the deposition potential and current density, a kinetic expression employing the Butler-Volmer equation is suggested and verified with the experimental findings. It was confirmed that the electroless nickel deposition processes in the present system was under a mixed control. The apparent activation energy determined by electrochemical methods was about 42.89 kJ·mol^-1.
作者 谢治辉 余刚
出处 《电化学》 CAS CSCD 北大核心 2014年第6期576-581,共6页 Journal of Electrochemistry
基金 四川省教育厅自然科学项目(No.14ZB0147) 中央高校基本科研业务费专项(No.13E006)资助
关键词 化学镀 极化 电化学机理 混合电势理论 沉积速率 electroless plating polarization electrochemical mechanism mixed potential theory deposition rate
  • 相关文献

参考文献25

  • 1Alkire R C, Kolb D M. Advances in electrochemical science and engineering (vol. 7)[M]. Weinheim: Wiley-VCH Verlag GmbH, 2001: Chapter 5.
  • 2Paunovic M, Vitkavage D. Determination of electroless copper deposition rate from polarization data in the vicinity of the mixed potential[J]. Journal of the Electrochemical Society, 1979, 126(12): 2282-2284.
  • 3Ohno I. Electroless copper plating from an iminodiacetate bath[J]. Surface Technology, 1976,4(6): 515-520.
  • 4Hung A, Ohno I. Electrochemical study of hypo phosphitereduced electroless copper deposition [J]. Journal of the Electrochemical Society, 1990, 137(3): 918-921.
  • 5Inberg A, Bogush V, Croitoru N, et al. Electrochemical study of the mechanism of Ag(W) electroless deposition [J].Journal of the Electrochemical Society, 2007, 154(1): DI-D4.
  • 6Petrov N, Sverdlov Y, Shacham-Diamand Y. Electrochemical study ofthe electroless deposition ofCo(P) and Co(W, P) alloys [J]. Journal of the Electrochemical Society, 2002, 149(4): CI87-CI94.
  • 7Kato M, Niikura K, Hoshino S, et al. Electrochemical behavior of electro less gold plating with ascorbic acid as a reducing agent[J]. The Surface Finishing Society of Japan, 1991,42(7): 729-735.
  • 8Mishra K G, Paramguru R K. Kinetics and mechanism of electro less copper deposition at moderate-to-high copper ion and low-to-moderate formaldehyde concentrations (1). Metallurgical and Materials Transactions B, 1999, 30(2): 223-229.
  • 9Mishra K G, Paramguru R K. Kinetics and mechanism of electro less deposition of copper[J]. Journal of the Electrochemical Society, 1996, 143(2): 510-516.
  • 10Li J, Kohl P A. The acceleration of non formaldehyde electroless copper plating[J].Journal of the Electrochemical Society, 2002,149(12): C631-C636.

二级参考文献21

  • 1Hung,A., Chen,K.M.J.Electrochem.Soc.,1989,156(1):72
  • 2Lee,C.H., Kim,J.J.Journal of Vacuum Science and Technology B,2005,23 (2):475
  • 3Sone,M., Kobayakawa,K., Saitou,M., Sato,Y.Electrochim.Acta,2004,49(2):233
  • 4Homma,T., Tamaki,A., Nakai,H., Osaka,T.J.Electroanal.Chem.,2003,559(1):131
  • 5Paunovic,M.Plating,1968,55:1161
  • 6Li,J., Hayden,H., Kohl,P.A.Electrochim.Acta,2004,49(11):1789
  • 7Lin,Y.M., Yen,S.C.Appl.Sur.Sci.,2001,178(3):116
  • 8Garza,M., Liu,J.Appl.Sur.Sci.,2004,222:253
  • 9Shacham-Diamand,Y., Lopatin,S.Electrochim.Acta,1999,44(21-22):3639
  • 10Chu,S.Z., Sakairi,M., Takahashi,H.J.Electrochem.Soc.,2000,147(4):1423

共引文献32

同被引文献33

  • 1Xiang Yanghui(向阳辉),Hu Wenbin(胡文彬),Shen Bin(沈彬)et a1.上海交通大学学报[J],2000,34(12):1638.
  • 2Tsai T K, Hsueh S J, Lee J H, et al. Journal of Electronic Materials [J],2012,41 (1):53-59.
  • 3Zhao Guanghong, Ren Chao, He Yedong. SusCace and Coatings Technology [J], 2012, 206 (11-12): 2774-2779.
  • 4Ranganatha S, Venkatesha T V. Physica Scripta [J], 2012, 85 (3) : 3560-3568.
  • 5Ying Lirda, Liu Ying, Liu Guannan, et al. Rare Metal Materials En- gineering [J], 2015, 44 (1): 0028-0031.
  • 6Luo Laima, Wu Yucheng, Li Jian. Suorctce and Coatings Technology [J], 2011,206 (6): 1091-1095.
  • 7Susumu Arai, Toshihiko Sato, Mofinobu Endo. Surface and Coatings Technology [J], 2011,205 (10): 3175-3181.
  • 8Ber~ot P, Pefia-Mufioz E, Pagetti J. Surface and Coatings Technolo- gY EJ], 2002, 157 (2-3): 282-289.
  • 9Sun X J, Li J G. Tribology Letters [J], 21307, 28 (3) : 223-228.
  • 10Fransaer J, Cells J P, Roos J R. Journal of Electrochemical Society [J], 1992, 139 (2) : 413--425.

引证文献1

二级引证文献2

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部