摘要
结合某过江盾构隧道,基于三维流体动力学模拟仿真软件平台,建立三维仿真模型,研究火灾发生在隧道盾构段典型区段时,排烟开口在火源上下游不同的分布模式时烟气层的温度场分布。通过分析模拟结果可知:随着火源上游排烟开口逐步增加,火源上游烟气逆流长度和蔓延速度都相对稳定而后又逐步增长,火源下游的烟气蔓延长度先减小而后又基本趋于稳定,下游烟气沉降高度则有所升高;火源位置处正上方温度则随着上游排烟开口的个数逐步增加而逐渐升高。而从其他的排烟开口变化模式模拟结果可知:随着排烟开口面积或者开口间距的逐步增大,烟气蔓延的速度先增加而后又逐步减小,且开口间距为30m左右时烟气蔓延速度相对较慢;排烟开口宽高比对烟气蔓延影响较小。所获得的结论将有助于相关类型工程的设计和管理。
A simulation model wasestablished in this work to investigate the effect of smoke vent arrangements on the smoke temperature distribution in the tunnel. It was found that the reverse flow moves faster and the downstream smoke slower with the increasing number of vents. Furthermore, the upstream reverse smoke flow distance is longer and the downstream flow distance is shorter. The maximum temperature above the fire source increases with the increasing number of vent in the upstream. In addition, the smoke spread rate first increases and then decreases with the increasing of smoke vent area and the distance of each vent, The smoke spread slowest at the distance of 30m. The ratio of length and height has limited effect on the spread rate.
出处
《火灾科学》
CAS
CSCD
2014年第4期203-209,共7页
Fire Safety Science
基金
中交建设股份特大科技项目(2010-ZJKJ-01)
关键词
隧道火灾
数值模拟
烟气控制
温度场
Tunnel fire
Numerical simulatiom Smoke control
Temperature field
