期刊文献+

强流脉冲下重复滑动电接触界面的电热特性 被引量:9

Electric and thermal characteristics of repeated sliding electric contact interface under high pulse current
下载PDF
导出
摘要 固体电枢电磁轨道发射中,膛内枢轨滑动电接触的电热特性关系到滑动界面的接触状态、电流传导品质和界面能量耗散,制约着系统效率和轨道寿命。设计开展了多组不同电流线密度的多发重复试验,通过采集电气试验数据进行迭代计算,得到了滑动接触电阻和界面焦耳热耗散功率的动态变化规律,分析了沉积物随重复发射的演变及电流线密度对电热特性的影响规律,并结合试验后轨道表面熔蚀沉积检测,讨论了滑动电接触界面的演变过程。结果表明:接触电阻稳定临界点和焦耳热耗散功率峰值点都出现在脉冲电流下降沿,接触电阻稳定值量级为10-2 mΩ,焦耳热功率峰值幅值可达10-1 MW;炮口速度随重复次数的增加而降低并趋于稳定,多次重复发射对滑动接触电阻和焦耳热功率较小的影响表明沉积物在发射中再次熔融并对电接触起积极作用;而即使输入能量一致,电流线密度的变化也显著影响了界面焦耳热的生成。 In solid electromagnetic rail launcher, electric and thermal characteristics of sliding electric contact between arma- ture and rails are related to contact status, current conduction and energy dissipation of sliding interface, influencing launcher sys tem efficiency and rail lifespan. Many repeated launch test groups under different maximum linear current density were designed and carried out. Through iterative computation with test electric parameters, dynamic variation rule of sliding contact resistance and interface joule heat power were obtained, and effect of melt deposition evolvement and linear current density on electro-ther real properties were further analyzed. With inspection of melting deposition on rails after repeated tests, interface evolution process of sliding electric contact in gun bore was discussed. Results show that the steady critical point of sliding electric contact resistance and peak point of interface joule heat power both came up during current falling-edge. Contact resistance value of steady phase can be reduced in 10-2m~, and the maximum value of joule heat power can reach 10-1MW. Contact resistance and heat power were affected hardly by repeated tests shows that deposition would re-melt and play positive role in sliding electric contact characteristic. Interface joule heat power was enlarged evidently by increasing linear current density even under the same input en ergy.
出处 《强激光与粒子束》 EI CAS CSCD 北大核心 2015年第5期255-262,共8页 High Power Laser and Particle Beams
基金 国家自然科学基金项目(51407195)
关键词 电流线密度 熔融沉积 滑动接触电阻 焦耳热功率 脉冲电流 电磁发射 linear current density melting deposition sliding contact resistance joule heat power pulse current electromagnetic launch
  • 相关文献

参考文献13

  • 1LiJun, Cao Ronggang, Li Shizhong. The development of EML technology in China[J]. IEEE Trans on Plasma Science, 2013, 41(5): 1029-1033.
  • 2Delaney L. A first report on electromigration studies at a modelcopper-aluminum railgun contact[D]. Monterey, USA: Naval Postgraduate School, 2006.
  • 3徐伟东,袁伟群,陈允,戴艺波,周媛,杨丹,严萍,李军.电磁轨道发射器连续发射的滑动电接触[J].强激光与粒子束,2012,24(3):668-672. 被引量:35
  • 4朱仁贵,李治源,张倩,王瑞林,邢彦昌.电磁发射枢轨界面初始接触状态研究[J].强激光与粒子束,2014,26(11):231-237. 被引量:17
  • 5Vanicek H, Satapathy S. Thermal characteristics of a laboratory electromagnetic launcher[J]. IEEE Trans on Magnetics, 2005, 41(1): 251-255.
  • 6Hsieh K T, Satapathy S, Hsieh M T. Effects of pressure-dependent contact resistivity on contact interfacial conditions[J]. IEEE Trans on Magnetics, 2009, 45(1): 313-318.
  • 7李鹤,雷彬,李治源,张倩,朱仁贵.电磁轨道炮试验过程中枢轨界面的接触电阻特性[J].高电压技术,2013,39(4):911-915. 被引量:26
  • 8陈允,徐伟东,袁伟群,赵莹,严萍,兰国峰.电磁发射中铝电枢与不同材料导轨间的滑动电接触特性[J].高电压技术,2013,39(4):937-942. 被引量:51
  • 9Dutta I, Delaney L, Clevel B, et al. Electric-current induced liquid A1 deposition, reaction, and flow on Cu rails at rail-armature contacts in railgun[J]. IEEE Trans on Magretics, 2009, 45(1) : 272 278.
  • 10Persad C, Castro Z. Railgun tribology: Characterization and control of multishot wear debris[J]. IEEE Trans on Magnetics, 2007, 43(1) : 173-177.

二级参考文献65

共引文献102

同被引文献59

引证文献9

二级引证文献32

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部