期刊文献+

后梁支座实型铸造工艺设计及凝固模拟 被引量:2

Process Design and Solidification Simulation of Girder Bracket Full Mold Casting
原文传递
导出
摘要 通过综合分析后梁支座的结构,考虑铸造工艺要求后,确定采用实型铸造工艺方案以避免采用普通砂型铸造造型困难的问题;在此基础上,确定该后梁支座的相应铸造工艺参数、浇冒口系统、工装等,并对其用华铸CAE软件进行铸造过程模拟和分析;得到了较为客观、准确的结果。 After a comprehensive analysis on girder bracket's structure, considering the casting process requirements, the way of Full Mold Casting Process was adopted to avoid the difficulty in common sand mold casting. On this basis, the corresponding casting process parameters, pouring riser systems and tooling of the girder bracket were further determined.Besides, the simulation software Hua cast CAE was used to analyze the casting process, and an objective and accurate analysis results was obtained.
出处 《铸造技术》 CAS 北大核心 2015年第5期1327-1329,共3页 Foundry Technology
关键词 后梁支座 铸钢 实型铸造 铸造过程模拟 girder bracket steel castings Full Mold Casting Process casting process simulation
  • 相关文献

参考文献4

二级参考文献3

共引文献30

同被引文献4

引证文献2

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部